Comelit RF2PIRAMW Manual De Instrucciones página 5

WARNINGS
• Avoid direct sunrays
• Avoid fixing the detector in spots exposed to atmospheric agents (rain, wind, big thermical changes ecc...)
• Avoid fixing the detector near reflecting objects that might influence it (puddle, glass, strobe lights etc..)
• Install the detector at a distance of at least 5 cm from useful shutters / blinds / mosquito nets / windows
• Where it is not possible to respect these distances it is recommended to disable the anti-blinding (DIP2 in ON).
•
Do not install near an air conditioner or heat exchangers that may cause temperature fluctuations
FIRST INSTALLATION
• Insert the battery in the transmitter and wait about 10 seconds.
• Make sure that the transceiver is in the learning mode in accordance with instructions from the control panel
programming alarm Comelit.
• Make a transmission by pressing and releasing the "tamper" detector; This starts in the data transmission of "learning"
from the device to the transceiver control panel.
EXAMPLE OF DETECTION AREA
FRONT
LATERAL
VIEW
VIEW
35°
50 cm
120 cm
EXAMPLE