Technical Data - KNOVA KN 7415-02P Manual De Instrucciones

SPECIFICATIONS
Specifications
Ram capacity 8 ton
Boom positions
2 Ton 73-5/8 in
1.5 Ton 78-1/4 in
1 Ton 84-1/4 in
0.5 Ton 92 in
Contents package
Part Description
A
Boom extension
B
Boom
C
Support post
D
Suppor braces
E
Hydraulic ram (8T)
G
Base legs
I
Handle
IMPORTANT NOTE
Sometimes, during shipment and handling,
air gets into the hydraulic system causing
poor lifting performance, purge air from
system by full opening release valve (turn
valve counterclockwise), while holding
end of ram cylinder down, operate pump
handle rapidly several times.
Pump handle assy
Release valve
Fig. 1

TECHNICAL DATA

Rated capacity
Lifting Cap.in Position 1:
Lifting Cap.in Position 2:
Lifting Cap.in Position 3:
Lifting Cap.in Position 4:
Weight:
Box A
Qty
Part Description
1 F
"A" Frame base
1 Assembly Hardware and
casters
1
2
DO NOT EXCEED RATED
LOAD CAPACITY
1
2
Check ram and plunger every 3 months
for ant signs of rust or corrosion clean
1
as needed and wipe with a clean oil cloth
when not using, hoist always leave ram
in down most position when adding or
replacing oil always use a good grade
of hydraulic jack
oil, avoid mixing
types of oil.
Do not use brake
fluid, alcohol,
glycerin,
detergent,
motor oil or dirty
oil. When adding
oil, must be very
careful not to
permit dirt or
other foreign
matter to get
into system.
Fig. 2
KN 7415-02P
Safe working load (SWL)
2 ton (tested to 50% overload)
2 Ton
1.5 Ton
1 Ton
0.5 Ton
84 kg
Box B
Locking
pin
Qty
1
Lot