Pentair S746 Guia De Inicio Rapido

Hazardous voltage! Can shock, burn, or kill. Disconnect
all power to the pool lights before starting this procedure.
Remove the trim ring and lamp from the niche
1
and set them on the pool deck.
Install the new ring behind the old ring. The
4
new ring should back up against the old ring. If
the old ring has come out, put it back into the
niche so that it is flush with the open end of the
niche can. Use it as a template to position the
new ring, and discard it when finished.
Sta-Rite Pool/Spa Group
293 Wright Street, Delavan, WI 53115
International: 262-728-5551, FAX: 262-728-7550
www.starite.com
Union City, TN • Delavan, WI • Mississauga, Ont. • Murrieta, CA
© 2004, Sta-Rite Industries
Pool Light Ring Replacement Instructions
Remove the old ring if it has become detached
2
from the niche. You will have to cut it to get it
past the cord.
Tighten the locknuts with a 7/16" wrench until
5
the ring is locked in place against the inside of
the niche. NOTICE: Tightening the nuts too far
can bend the bolt and ruin the ring, so BE
CAREFUL!
4513 0204
NOTICE: In the drawings, the pool wall, liner, and (in some) the lamp
are omitted for clarity. Do not remove the niche from the pool wall.
4511 0204
Printed in U.S.A.
Put the new ring around the lamp cord and
3
install the double-ended bolt and nuts in the ring
ends. Run the nuts in to allow the ring to spring
into place. Slide the new ring into the niche with
the bolt as close to 9-o'clock as possible.
4512 0204
Reinstall the lamp and trim ring. Coil the cord
6
around the lamp. Make sure that the lamp's
bottom hook catches the bottom catch of the
new ring.
S746 (2/13/04)