Descargar Imprimir esta página

SEVERIN Mix & Go Instrucciones De Uso página 12

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 27
dangerous.
∙ No responsibility will be accepted if
damage results from improper use, or if
these instructions are not complied with.
Before using for the fi rst time
Before the appliance is used for the fi rst
time, the blender jug, lid and stopper,
grinding top and blade assembly should
be thoroughly cleaned, as described in the
section Cleaning and care.
Switch settings
The following settings can be selected:
P
The appliance remains switched at high
speed on as long as the rotary switch is
held in this position
0
The appliance is switched off
I
Low power
II
Maximum power
Short-term operation
The appliance is designed to process
average domestic quantities of food; it
can be operated without interruption for a
maximum of 3 minutes with the blender jug,
or up to 30 seconds with the grinding top,
after which it should be allowed to cool down
to room temperature.
Safety switch
A special safety switch in the motor housing
ensures that the appliance can only be
operated if the blender jug or grinding top is
properly locked in position.
Before removing either of these, make sure
that the rotary control is in position 0. This
also applies when fi tting the blender jug
or grinding top to the motor housing. If the
control is not in its off-position (0), the motor
12
All manuals and user guides at all-guides.com
will start immediately.
Multi-mixer operation
∙ Fit the blender jug to the motor housing,
∙ Put the liquid ingredients into the blender
∙ Replace the lid so that the spout is
∙ The lid must be fi tted at all times
∙ To add ingredients during operation, the
∙ Insert the plug into the wall outlet and use
∙ Caution: Do not operate when the
∙ After using the blender, switch off and
Using the multi-mixer to crush ice
Ice-cubes can be easily crushed in the
blender jug:
Fill the jug a quarter full with ice cubes, and
then fi t it to the motor housing, as described
in the section Multi-mixer operation. Put on
the lid with the stopper in place, and use the
pulse function (P) to operate the appliance
with its handle to the right, in such a way
that the two triangle symbols are aligned.
jug. The jug has a maximum capacity of
1000 ml. To avoid possible foaming or
spilling when processing foamable or thin
liquids such as milk, do not fi ll the jug over
the 700 ml mark.
completely covered.
whenever the mixer is operated.
stopper in the centre of the lid can be
removed. Do not put any objects into
the blender jug while the appliance is
operating.
the rotary control to select the required
power setting.
blender jug is empty. Do not fi ll it with dry
items only, such as nuts, almonds etc.
remove the plug from the wall socket.
Wait until the motor has come to a
complete standstill before removing the
blender jug.

Publicidad

loading