Leggett & Platt E-95MR Guía De Operación página 6

e-95MR ReMote contRoL pRogRaMMing (1 remote control - 1 base)
Program One Remote to Operate One Base - your adjustable
base will be equipped with one of the following: (A) a DC motor
with a power down box, (B) an AC J box, (C) a DC motor without
a power down box (FIGURE 2).
a
LEARN
BUTTON
b
AC J BOX
AC J BOX
(MOUNTED
TO BOTTOM
SIDE OF BASE
FRAME)
c
DC MOTOR-NO
POWER DOWN
BOX
FIGURE 2: Power down box, AC J box and DC motor.
step 1
(A) DC motor with a power down box: press
the learn button on the power down box for 1
second.
(B or C) AC Jbox or DC motor without power
down box: unplug the adjustable base electrical
power cord. Wait 30 seconds, then plug the
cord back into the power source.
6
E-95MR Remote Control Operation Guide 99300791-d
POWER DOWN
BOX (NOT
POWER
MOUNTED TO
DOWN BOX
BASE FRAME)
LEARN
BUTTON
DC MOTOR
(MOUNTED TO
BOTTOM SIDE OF
BASE FRAME)
step 2
On the remote control, simultaneously press
and hold the flat and head massage on/off
buttons (FIGURE 3). The transmission indicator
light will flash slowly and then flash rapidly to
indicate programming mode. Continue to hold
for 5 seconds and then release the buttons.
One remote control is now programmed to
operate one base.
FLAT
BUTTON
HEAD
MASSAGE
ON/OFF
BUTTON
FIGURE 3
TRANSMISSION
INDICATOR LIGHT