Cleaning And Maintenance - Concept SR3300 Manual Del Usuario

EN
OPERATING INSTRUCTIONS
NOTICE
Always disconnect the plug out of the electrical outlet before assembling or removing accessories! Before putting a new
appliance into operation, you should wipe it thoroughly with a damp cloth and wash all removable parts in warm water
for hygienic reasons.
Never use different adapters at the same time!
Whisks and dough hooks
Whisks are intended for whipping mousse, cream, egg yolks, preparation
of various cremes or runny dough for omelettes and pancakes.
Dough hooks are intended for preparing rubbed, yeast, gingerbread
dough, etc.
The maximum continuous operation time of the appliance (KB) is
5 minutes at speeds 1–5. Then let the appliance cool down for at least
15 minutes.
1. Insert the whisks/whisk or dough hooks into the holes in the bottom
part of the appliance and turn them slightly until they are firmly
attached.
Caution! Insert the whisk or dough hook with ring (Fig. 1) into the larger hole.
2. Unwind the power cord completely. Make sure it does not touch any nearby heat sources. Insert the plug into the
wall outlet.
3. Hold the appliance body with one hand and the whipping/kneading bowl with the other.
4. Insert the whisks/whisk of the appliance (or dough hooks) into the bowl with food and set the required speed. Press
the PULSE button (4) to briefly increase the speed to the maximum.
5. After you have finished whipping/kneading, switch off the appliance. Unplug the power cord from the socket.
6. Press the EJECT button (1) to release the whisks or dough hooks and rinse them immediately under warm running
water.
Caution! When using the appliance, do not touch the walls of the bowl with the whisks/dough hooks. Otherwise,
it could cause a malfunction.
Caution! To prevent overheating, do not let the appliance run for more than 10 minutes. Let the appliance to
cool down to room temperature before restarting it.
Immersion blender
The stick adapter is intended for preparing sauces, toppings, soups, mayonnaise, baby food, mixed drinks and milkshakes.
1. Put food in the blending bowl (F) or any other higher kitchenware.
2. Place the appliance body (A) on the shaft of the stick adapter (E) and turn it to lock it (pull it make sure that the stick
adapter cannot be separated from the body of the appliance).
3. Unwind the power cord completely. Make sure it does not touch any nearby heat sources. Insert the plug into the
wall outlet.
4. Hold the appliance body with one hand (A) and the blending bowl (F) with the other.
5. Move the buttons (3) to the L or H position to set the speed of the appliance. Insert the adapter into the blending
bowl (F) with food and press the PULSE button (4) to switch it on. Blend the food in a circular motion at the bottom
of the bowl.
6. After you have finished blending, switch off the appliance. Unplug the power cord from the socket.
7. Turn and pull to remove the stick adapter from the appliance body and rinse it immediately under warm running
water. Make sure that water does not get into the inside of the adapter to the drive shaft area. If this happens, let
the stick adapter to dry and drip a few drops of edible oil into the drive shaft area to ensure better run of the stick
adapter bearing.
Caution! To prevent overheating, do not let the appliance run for more than 1 minute. Let it cool down to room
temperature before restarting the appliance. Do not let the appliance run idle and do not blend dry food.
38
Chopper (for SR3310)
Do not chop extremely hard foods such as nutmeg, coffee beans and grains. Cut food such as meat, cheese, onions,
garlic, carrots and frozen foods first. Remove stems from herbs, remove shells from nuts, remove bones, tendons and
cartilage from meat.
Caution! The blades are very sharp, be extremely careful when manipulating with them!
1. Insert blades (H) into the chopping bowl (I) so that they fit on the metal axis.
2. Put the food into the chopping bowl and close it with a transmission lid.
3. Place the appliance body (A) on the transmission lid (G) and turn it to lock it.
4. Unwind the power cord completely. Make sure it does not touch any nearby heat sources. Insert the plug into the
wall outlet.
5. Hold the appliance body with one hand (A) and the chopping bowl (I) with the other.
6. Move the buttons (3) to the L or H position to set the speed of the appliance. Press the PULSE button (4) before
chopping.
7. For better blending results, switch the appliance on and off every few seconds.
8. After you have finished blending, set the speed of the appliance to 0 and switch the appliance off. Turn the appliance
Fig. 1
body (A) and then pull it to remove it from the transmission lid. Unplug the power cord from the socket.
9. Wipe the transmission lid (G) of the chopping bowl with a damp cloth. Do not wash it under running water and do
not immerse it in water!
Caution! To prevent overheating of the appliance, do not let it run for more than 1 minute at a time. Let the
appliance to cool down to room temperature before restarting it.
Caution! When using the hand mixer, do not release the dough hooks / whisks / whisk / blades. Manipulate with
the accessories only after they have stopped moving completely.
Indicative instructions for use
Speed
1 Blending/mixing
2 Slow whipping
3 Blending and whipping
4 Blending and whipping
5 Blending and fast whipping
Blending with immersion blender
PULSE
Chopper

CLEANING AND MAINTENANCE

Before cleaning and after use of the appliance, switch the appliance off and disconnect it from the mains.
Wipe the appliance body with a damp cloth.
Do not use pot scourer, abrasives solutions or solvents for cleaning.
Wash whisks and dough hooks with a warm detergent water and rinse with clean water or wash them in a dishwasher.
SR3300|SR3310 SR3300|SR3310
Use
Blending a large amount of ingredients or dry ingredients
such as flour, sugar, etc.
Whipping fluid into bulk ingredients.
Whipping cake dough.
Whipping cake dough.
Whipping cake dough.
Blending fruits and vegetables.
Chopping fruits, vegetables and meat.
EN
39