Hdd Media Player Operation; Setup; Dtv - aqprox appMPR1TDT Guia Del Usuario

All manuals and user guides at all-guides.com
2. HOW TO CONNECT TO TV
Connect HDD player to TV by AV/HDMI cable.
Warming: confirm the Video output setting is the same with your TV mode. Press the
R/C HDMI/AV button to set up the output mode on you HDD media player.
3. HOW TO CONNECT THE POWER SUPPLY
1. Connect the AC adapter cable plug in the unit system's jack.
2. Plug the AC adapter into wall outlet.
Warning:
Power supply must be DC 12V/3A; don't connect the unit with wrong adapter,
Set up the unit on "STANDBY" mode before cut off power supply to avoid the hard
disk leads to irreparable destroy.
3. HOW TO CHANGE R/C BATTERY
1. Put out the Battery door, the battery door is located on the rear housing. Simply pull
the tab to open the battery door.
2. Position the battery (including) so it sits in the battery holder correctly, make sure
the polarity (the + and the – sides of battery) is correct.
Notes:
1. Remote control operation range: Within 6m from front panel, angle: <60°
2. Effective distance of remote control will be difference according to different
lightness of environment.

HDD MEDIA PLAYER OPERATION

Turn on the unit, HDD media player reads hard disk information, screen displays the
main menu, press the R/C direction button to select title or submenu, then press Enter
button to confirm the highlight item.

1. SETUP

Press SETUP key on the RC to enter setup interface, there are 6 icons in it. Press
RIGHT/LEFT keys to choose the icon, after you choose an icon, use UP/DOWN keys
to choose the selections, press RIGHT/LEFT to choose the sub-selection, then press
UP/DOWN to highlight the sub-selection, use ENTER key to confirm. The TV
SEARCH selection only function in DVB-T mode.

2. DTV

Press the DTV Icon on the main menu to enter the DTV mode.
25