IP Cleaning ISY C/ACC Manual De Instrucciones página 28

6. Remove the filter
7. Insert the new filter into the filter
frame and place it on the head
8. Fix the 4 screws. Do not over
tighten the screws.
9. Check the filter is properly fixed
and the sealing between head and
filter frame is secured.
5. Trouble shooting
Repair or service
components such as cord or
motor, must only be carried out
by an authorized service centre.
If the machine does not start (AC Isy)
• Check that the plug is correctly
fitted to the wall socket.
• A fuse in the building may have
blown and needs to be changed.
of electrical
• The
cord
damaged and must be repaired
by an authorized service centre.
Reduced suction power
• The tank (2) may be full and
needs to
instructions.
• The filter (11) can be blocked
and have to be cleaned, see
chapter 3.2
• The hose or nozzle may be
blocked
cleaned.
6. Noise
Values measured according to :
EN 60704 - 1 (1997) / EN 60704 -2 - 1
(2001) rules.Measurement A for the
sound pressure level of the machine
is <80dB(A) Under unfavourable feed
conditions, the appliance may cause
temporary drops in voltage.
7. Blower feature (Isy only)
Push hose into blower port placed on
the vacuum head. Turn the switch on.
28
EN
or plug may
be emptied,
and needs to
be
see
be