Items Included - Bosch GTA 60 W Professional Manual Original

Saw stand
Saw stand height
Max. load bearing capacity
(power tool + workpiece)
Weight according to EPTA-Pro-
cedure 01:2014
Assembly

Items included

See the list of items included at the start of
the operating manual.
Check to ensure that all the parts listed below have been
supplied before assembling the saw stand:
No. Designation
(1) Mounting plate
(6) Upper frame with locking mechanism (2)
(7) Lower frame
(8) Wheel with linkage bar (9)
(10) Foot support
(11) Fastening set consisting of:
– Hexagon screws
M10 x 100
M10 x 50
M6 x 110
M6 x 75
M6 x 45
– Cross-head screws
M8 x 5
– Washers
M10
M10 (clamp disc)
M6
– Lock nuts
M10
M8
M6
Extra tools required (not included in the delivery):
– Cross-headed screwdriver
– Spanner (10 mm, 8 mm, 6 mm)
Assembling the Mobile Base Unit
– Carefully remove all parts included in the delivery from
their packaging.
– Remove all packing material.
– For assembly, follow figures A − E.
Bosch Power Tools
For figure A:
GTA 60 W
– Screw together the upper frame (6) and the lower
mm 622
kg 180
For figure B:
– Screw the left and right wheels (8) onto the upper
kg 24
When doing so, ensure that the linkage bars (9) are facing
outwards and that the tyres of the wheels are facing towards
the lower frame (7).
Note: Do not over-tighten the nuts. The screwed-together
parts must be able to move freely.
For figure C:
– Screw together the foot support (10) and the two
For figure D:
– Screw the mounting plate (1) on both sides to the upper
Quant-
Note: Do not over-tighten the nuts. The screwed-together
ity
parts must be able to move freely.
1
For figure E:
1
– Screw the left and right linkage bars (9) onto the mount-
1
Note: Do not over-tighten the nuts. The screwed-together
2
parts must be able to move freely.
1
Preparing the Saw Stand
Setting up the Saw Stand (see figure F)
6
Before securing the power tool, you must pull the base unit
2
apart.
4
– To release the lock bolts (4), gently pull the saw stand up-
4
4
– Open the locking mechanism (2). This retracts the lock
6
– Place one foot on the foot support (10) and push the
18
2
– Close the locking mechanism (2).
8
The height-adjustable feet (5) will help you to straighten the
saw stand.
6
– Undo the wing nuts (12) and screw in/out the feet until
6
4
Securing the Power Tool to the Mounting Plate
(see figure G)
The mounting plate (1) is suitable for general use. The vari-
ous different mounting holes allow both Bosch power tools
and competitor products to be mounted on the saw stand.
frame (7).
frame (6).
wheels (8).
frame (6).
ing plate (1).
wards by the handle (3).
bolts which lock the wheels.
handle (3) downwards with both hands until the lock
bolts engage again.
the saw stand is level.
1 609 92A 5YE | (23.10.2020)
English | 9