tomado TRW2401B Instrucciones De Uso página 18

REPLACING THE LED LAMP
This appliance has been provided with a LED lamp. This lamp lasts for a longer period of time. When the LED lamp in the
appliance is broken, you are not able to replace it yourself. Contact the Tomado service department.
Breakdown
The appliance no longer
works
Temperature in the
appliance is too high
or too low
Condensation in the
appliance.
Unusual or loud noises
The appliance is
very warm
During normal use of the cooling appliance, different types of noises can occur that do not have any effect on the correct
operation of the appliance.
Noises that can be heard during normal use of the appliance are caused by the operation of the thermostat, compressor
(activation), cooling system (shrinkage and expansion of the material under the influence of temperature differences and flow
of cooling liquid).
This symbol means that this product should not be disposed of with regular household waste (2012/19/EU).
Observe the rules that apply in your country for the separated collection of electric and electronic products.
Correct disposal of the product prevents negative consequences for the environment and for public health.
The packaging material of this product can be recycled 100%, return packaging material separately.
RESOLVING FAILURES YOURSELF
Cause
The plug is not in the socket.
Power interruption.
Incorrect temperature setting.
The door of the appliance is opened too
frequently or remains open for too long.
The ambient temperature is higher or lower
than the temperature indicated in the table
with technical data.
The appliance is located in direct sunlight or
near a heat source.
Condensation may occur on the outside and
at the door rubbers, when the appliance is
in an environment with a high air humidity.
The appliance is not level and stable.
The appliance is standing against
something.
The condenser is located at the rear of the
appliance.
RECYCLING
Solution
Insert the plug into the socket.
Check the fuses in the group box.
Set the thermostat to a different position.
Open the door less often and/or reduce the time
that the door remains open.
The appliance is intended for operation in an
ambient temperature indicated in the table with
technical data supplied with the appliance.
Change the location of the appliance according to
the instructions in the instruction manual.
Wipe the condensation off the appliance using
a dry cloth and check that the temperature is
set correctly.
Level the appliance with the adjustable feet.
Place the appliance in such a way that it is not
standing against anything.
It is normal for the exterior to become warm.
EN - 18