Intended Use; Product Description; Installation And Maintenance - Quick QCC-DRV CH4 Manual De Uso Y Mantenimiento

CHARACTERISTICS / INSTALLATION / OPERATION
EN

INTENDED USE

• The QCC-DRV CH4 is intended to be used in nautical applications to control the colour and adjust the brightness of
RGBW LED light sources in constant current.
• For fire-prevention reasons, install the QCC-DRV CH4 in a ventilated, controlled-temperature environment, protected
from dust and humidity. Do not expose the dimmer pack to rain or humidity.
• Any other use should be considered improper and unpredictable.
READ THESE INSTRUCTIONS CAREFULLY BEFORE USING THE PRODUCT. IN CASE OF DOUBT,
CONTACT YOUR DEALER OR QUICK
THE PACKAGE CONAINS: QCC-DRV CH4 - conditions of warranty - the manual of installation and use.
TECHNICAL ELEMENTS AND DEFINITIONS
• sorgenti luminose a LED RGBW: In this specific manual, these are lighting devices that use a RGBW LED or a LED for
each of the RGBW colours. Ognuno dei quattro canali è da pilotare in corrente costante.
• segnale di controllo: In this specific manual, it is the electrical signal generated by the QCC-PLT 300 and which
contains the necessary information for the QCC-DRV CH4 driver operation.

PRODUCT DESCRIPTION

The QCC-DRV CH4 is a module to adjust light intensity and colour in a RGBW
system.
This function is active only if the device is coupled and appropriately connected
to Quick QCC-PLT 300.
®

INSTALLATION AND MAINTENANCE

• The device must be placed in a suitably protected distribution board so that it can operate under the environmental
conditions indicated in the general specifications for use, and is not within reach of personnel who are not qualified.
• Always disconnect the supply voltage during installation and maintenance operations.
• Make the connections following the best practices, using cable of adequate type and size that are appropriate for the
environment conditions.
• Critically inspect your work immediately after installing or servicing the product.
OPERATION
The QCC-DRV CH4 receives an input control signal on two wires from the QCC-PLT 300 by Quick
power and the instructions to be turned in constant current power for the four output channels.
These four channels in constant current drive the LED RGBW light sources. With electrical installation at 12V, each QCC-DRV
CH4 drives up to three RGBW LED light sources. At 24 V, it drives up to six.
Wiring, terminals and cables
Considering the high currents involved, a few precautions on wiring are in order:
• The maximum length of the wires used for the control signal is 200 metres.
• Use cables having an adequate cross-section.
• To connect the QCC-DRV CH4 to the RGBW LED light sources, use shielded Ethernet cables (FTP), type CAT5e and with
RJ-45 male-to-male connector.
* The RJ-45 male-to-male connector is not supplied together with the QCC-DRV CH4.
F
In case of discordance or errors in translation between the translated version and the original text in the Italian language,
reference will be made to the Italian or English text.
F
Quick ® reserves the right to modify the technical characteristics of the equipment and the contents of this manual without prior
notice.
CUSTOMER SERVICE.
®
8
QCC-DRV CH4 - REV001A
, from which it receives the
®
QUICK SPA