VDL INNERGIZE HP8580 Manual Del Usuario página 7

Problem
The tanning results not as
good as I expected.
The appliance does not
produce enough
fragrance.
An E-code appears on
the display and/or the
appliance beeps.
Solution
Perhaps you use an extension cord that is too long and/or does not have
the correct current rating. Consult your dealer. Our general advice is not to
use an extension cord.
You may have followed a tanning course that is not appropriate for your
skin type. Check the table in chapter 'Tanning and your health' , section
'Tanning sessions: how often and how long?' .
The distance between the lamps and the surface you lie on may be larger
than prescribed. See chapter 'Preparing for use' .
When the lamps have been used for a long time, the tanning
capacity decreases. This effect only becomes noticeable after several years.
To solve this problem, select a slightly longer tanning time or have the
The
lamps replaced.
hours to indicate that it is advisable to replace the lamps.
The tanning result depends on your skin type and the tanning course you
are taking. The first effect only becomes visible after a few sessions.
Read the last part of section 'Natural fragrances' in chapter 'Using the
appliance' .
Stop using the appliance and unplug it. Wait two seconds and put the plug
back into the wall socket. Contact your dealer or a VDL Hapro service
centre if the problem reoccurs.
symbol appears on the display after 750
ENGLISH
9