HARDWARE RESOURCES 5000 Serie Instrucciones De Instalación

5000 Series
Medium Duty Slides
Installation Instructions
1. Slides are identified as:
Cabinet member, left (CL), Cabinet member, right (CR),
Drawer member, left (DL), Drawer member, right (DR)
2. Install Drawer Members:
Place drawer members on the bottom lip of the drawer.
Roller is positioned toward the rear of the drawer. Place
front edge of each member against the rear face of the
drawer front. Screw DL and DR using 4 #6 x 1/2" screws
per member. The side or bottom screw holes can be
used.
3. Install Cabinet Members:
• 32mm Frameless Cabinets:
The hole pattern on the inside of the cabinet front
should be set back 37mm from the cabinet face.
Place the CL and CR 2mm from the front edge of the
cabinet, in order to align it with the cabinet's vertical
32mm euro hole pattern. Vertically align and screw
the CL and CR using 4 #6 x 1/2" screws per member.
Two screws are used in the front and two in the rear.
• Face Frame Cabinet:
Place CL and CR flush with the front and bottom
of the cabinet opening. Rollers are located at the
front. Ensure that the CL and CR are perpendicular
to the cabinet front, parallel to each other, and in a
level position. A shim may be necessary to insure a
parallel position with the side of the cabinet. Screw
the CL and CR members using 4 #6 x 1/2" screws per
member. Two screws are used in the front and two
in the rear.
4. Drawer Installation:
Insert the DL and DR rollers over the CL and CR rollers.
Slight adjustment of either CL or CR position may
be necessary to insure a smooth and even drawer
movement.
Bossier City, LA
www.HardwareResources.com
Hole Pattern and Length Specifications
DRAWER MEMBER
100
10 10
34 A
Specifications
CABINET MEMBER
36
CL HR5000
5.5
5.5X8
35
67
163
259
B
10
L A B
22" 550 235 235
20" 500 210 210
18" 450 185 185
16" 400 160 160
14" 350 135 135
12" 300 110 110
6.5
A
Specifications A
22" 515
20" 451
18" 387
16" 355
14" 323
12" -
45
9.5
10 10 15