Publicidad
Assembly Instructions
(continued)
Step 3
Secure the large bolt (E3) by allen key (F) to attach
base with both legs (B).
Place table top and frame (A) onto a clean, padded
surface. Dismantle the frame from the top by philips head
screwdriver, keep the countersunk bolts (E1) for later step.
Note: the leg with bag hook shall be placed to the
right side with the hook facing outwards.
Step 4
Put the release handle (C) into slot of the top adaptor of
the legs, the handle should point to front.
Put nylon block spacer (E4) into the slot of the table
top adaptor of both legs, right above the pin of release
handle.
Place frame on to the top adaptor of legs and attached
them together with small bolts (E2).
Step 5
Place the table top on to the frame and attach by
countersunk bolts.
Press release both handles to adjust the table height
if needed.
How to use
Height Adjustment
To change the height of the table top, press the handle at both sides of the
table. Then push or pull to the desired height and release the handle.
680mm – 1020mm
Cautions
MAX LOAD OF 25KGS ON
THE TABLE-TOP
MAX LOAD OF 5KGS ON
THE PERSONAL BAG
HOOK
LIFT EDDY
FRONT END GENTLY
WHEN MOVING
RELEASE HANDLE
AND MAKE SURE THE
HEIGHT ADJUSTABILITY
IN PARALLEL LEVEL
MOVE EDDY GENTLY
TO AVOID CRASHING
INTO THE WALL OR
OTHER OBJECTS
Publicidad
