Care Instructions - Scosche RHYTHM+ RTHM1.9EU Manual De Usuario

USING THE ARMBAND MONITOR
Wear armband on the upper portion of the forearm. Sensor should be on
the inside or top of forearm. It should be worn snug enough not to move
on your arm, but NOT so tight that it restricts arm circulation (Figure 3).
Initial Setup with
1. Set 8/uetooth on the device to ON.
2. Find the Sensor Settings menu in the Bluetooth Smart Fitness App.
3. Connect the RHYTHM+ armband by turning it on.
Initial Setup with
(Sports Watches & Fitness Equipment)
1. From the device settings menu select "Add HR sensor"
2. Connect the RHYTHM+ armband by turning it on.
Initial Setup with ANT+ devices
Turn on the armband and move within range of your display device.
Note:
Heart Rate Monitoring will work with most 8/uetooth Smart Fitness Apps.
For a list of compatible Apps, please vistt www.scosche.com.
LED Indicators (Bluetooth Smart Operation)
1. Alternating RED/BLUE - the armband is waiting for a connection.
a) Annband will only power down if removed from the forearm for more than
5 minutes.
2. Three (3) BLUE blinks - the armband has connected successfully.
3. Slow PURPLE blink - the HR monitor is on and in nonnal operation.
LED Indicators (ANT+ Mode)
1. RED blink - the HR monitor is on and in normal operation.
• To ensure accurate readings, clean the sensor lens with a soft cloth.
• Use a soft cloth wtth ONLY mild hand soap and cool water to wipe down the
armband, sensors and plastic housing.
• Use a cotton swab and ONLY rubbing alcohol to clean the charging contacts.
• Do not use any abrasive chemicals to clean the RHYTHM+ Annband,
sensors or plastic housing. This will cause pennanent damage.
FIGURE3
Bluetooth Smart
Bluetooth Smart
(Sports Watches & Fitness Equipment)

CARE INSTRUCTIONS

3
--------
�
Fitness Apps
devices