Mobiclinic Nilo Manual De Instrucciones página 21

ES EN FR IT
NL NL ES
Opera
To turn on the heater:
1. Turn on the valve on the gas supply cylinder completely.
2. Press and turn the variable control knob to PILOT position (counter-clockwise
90º).
3. Press down the variable control knob and hold for 90 seconds. While holding
down the variable control knob, press the igniter button several times until the
pilo hts. Release the variable control knob after the pilo
Note:
- If a new tank has just been connected, please allow at least one minute for the
air in the gas pipeline to purge out through the pilot hole.
- When lighting the pilot
continuously pressed down while pressing the igniter button. Variable control
knob can be realeased after the pilo
- Pilot can be watched and checked from the small round window with
sliding lid located at the bottom of the
controller).
- If the pilo
4. After the pilot
and leave it there for 5 minutes or more before turning the knob to desired
temperatura position.
To turn o the heater:
1. Turn the variable control knob to PILOT position.
2. Press and turn the variable control knob to OFF position.
lgniter
Igniter
3. Turn o the valve on the gas supply cylinder completely.
Storage
1. Always close the gas valve of the gas cylinder ofter use or in case of disturbance
2. Remove the pressure controller and the hose.
3. Check the tightness of the gas valve and for damage. If you suspect a damage,
have it changed by your gas dealer.
4. Always turn o the gas valve after use. If damage is suspected, bring it to the
attention of
8
DE PT
NL SWE
st r
make sure that the variable control knob is
ot light or it goes out, repeat step 3.
lights, turn the variable control knob to maximum position
Variable control knob
technician.
PL
hts.
screen (to the left or right side of the
Off: the heater stop work
Hi: maximum temperature position
Lo: minimum temperature position
Nilo
hts.