Buffalo FS440 Manual De Instrucciones página 5

Assembly
Before assembly, ensure to
• Disconnect the power pack from the
power supply.
• Clean all removable parts thoroughly.
1. Align and insert the pins of the shaft into the
lock sleeve of the power pack.
2. Screw the shaft as arrow shown into the power
pack securely.
Pin
Shaft
Blending
1. Ensure the ON/OFF button (3) is in the
released position.
2. Select speed using the variable speed dial (1).
3. Connect the appliance to the power supply.
4. Press and hold the safety button (2) with one
hand.
5. Press and hold the ON/OFF button to start
the blender. Now you can release the safety
button.
6. To stop the blender, just release the ON/
OFF button. The safety button will release
automatically.
FS440-FS441-FS442_ML_A5_v1_20211118.indb 5 FS440-FS441-FS442_ML_A5_v1_20211118.indb 5
Continuous blending
Follow steps1 to 5 as above, then:
1. While the ON/OFF button is in the depressed
2. Now release the ON/OFF button. The appliance
3. To stop the appliance, just press the ON/OFF
•
•
Sleeve
•
•
Removing the lodged food
If a piece of food gets lodged in the protective
blade guard surrounding the metal blade, please
follow the instructions below:
1. Turn off blender, disconnect from power supply
2. Remove the shaft from the power pack.
3. Use a spatula to carefully remove the food
1
2 4. Re-attach the shaft, plug unit back in and
3
4
position, press the LOCK button (4).
will function continuously.
button once.
For greater control, we recommend
holding the blender by the handle
and the bottom of the power pack.
Furthermore, it is recommended to tilt
the bender slightly to prevent the blade
guard from touching the bottom of the
container.
Always make sure that the blade
guard is sufficiently immersed to avoid
splashing and that the air vents of the
motor unit does not come into contact
with any liquid. For optimum efficiency,
two thirds of the shaft should be
immersed during preparation.
During use, the stainless steel shaft
may become hot. Take care not to touch
it.
It is advisable to start at a low speed.
and let it come to a complete stop.
lodged in the blade guard. The blade is
sharp - Never attempt to use fingers to
remove any lodged object.
continue blending.
UK
5
2021/11/18 16:32 2021/11/18 16:32