Premier ED-5427T Manual De Instrucciones página 13

PARTS IDENTIFICATION
1. Water tank
2. Water filling inlet
3. Steam button
4. Temperature control dial
5. Cord protector
6. Pilot light
7. MAX. water level
8. Soleplate
IMPORTANT
~ Ensure the voltage on the type plate is the same as that in your home.
~ The iron should always be turned to off before plugging or unplugging from the wall socket.
~ Never yank the cord to disconnect from the wall socket; instead, grasp plug and pull to disconnect.
~ Never use the appliance if damaged in anyway.
~ When leaving, even when only for a short while, always unplug the iron.
~ Close supervision is necessary for any appliance being used by or near children.
~ Do not leave the iron unattended white connected or on an ironing board.
~ Burns can occur from touching hot metal parts, hot water or steam.
~ Use caution when you turn a steam iron upside down - there may be hot water in the reservoir.
~ Never immerse the iron in water.
~ Always place the iron with its back on a firm flat surface when interrupting ironing and after use.
~Keep the soleplate smooth, avoid hard contact with a metal object.
~ The cord should not be allowed to touch the sole plate when it is hot.
~ Prevent water overflow. Do not fill over max level.
~ When using the iron for the first time test on an old piece of fabric to ensure the sole plate and water
tank are completely clean.
~ This appliance can be used by children aged from 8 years and above and persons with reduced
physical sensory or mental capabilities or lack of experience and knowledge if they have been given
supervision or instruction concerning use of the appliance in a safe way and understand the hazards
involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made
by children without supervision.
~ Keep the iron and its cord out of reach of children less than 8 year of age when it is energized or
cooling down.
FILLING WITH WATER
~ Ensure the iron is disconnected from the power supply.
~ Turn the steam control knob to position "0"
Fill with water through water filling inlet. (Do not exceed main level mark on the water tank.)
SETTING THE TEMPERATURE
'**Synthetics-Silk
'**wool
'**Cotton-Linen
- Stand the iron upright
P-2
All manuals and user guides at all-guides.com