Attaching To The Mast (Mast Not Included); Routing The Cable To Your Tv/Fm Receiver - Philips SDV4400/27 Manual Del Usuario

Insert the top and bottom wing booms into
4
the wing boom brackets. Secure them with
the four supplied 1¼-inch screws and small
wing nuts, as shown.
4
Wing Boom
1 / - Inch Screws
1
4
Wing Boom
Hold the main boom's elements near the
5
pivot points and pull them away from the boom
until they snap into the locking support brackets.
Note
D
You may wait to unfold the elements until you
get the antenna up on the roof or in your attic.
B Warning
Do not pull the elements near their outer ends
or you could damage them.
3.4 Attaching to the Mast
Note
D
We recommend you get the help of another
person before you put up the mast or attach
your antenna to it. How you set up your mast
depends on your specific installation. Refer to the
separate Consumer Product Safety Commission
Information for recommended methods.
Slide the antenna's mast clamp assembly
1
over the end of the mast, with the plastic
brackets on top.
Tighten the mast clamp assembly's lock
2
nuts to hold the antenna in place. Do not
overtighten the lock nuts.
Warning
B
The crossover wires must not touch the
antenna boom, the mast, or each other.
If necessary, carefully bend the crossover wires
to provide at least 1/2 inch of clearance.
6
All manuals and user guides at all-guides.com
Crossover Wires
4
Wing B
Element
Set up the mast, then rotate it so the
3
Small Wing Nuts antenna's shortest elements point toward
the stations you want to receive. Then
secure the mast into position.
D Note
You can also put the antenna in an attic space.
You can mount it from a rafter or place
the antenna on the attic floor. However, we
(mast not included)
recommend you use mounting hardware for a
secure attic installation.
3.5 R outing the Cable to Y our TV/FM
Receiver
Use plastic tape to secure the coaxial cable
1
to the mast at about 3-foot intervals.
Use coaxial nail clips every few feet to
2
secure the cable between the mast and
where the cable enters the house.
Use a 75 ohm grounding block at the point
3
where the cable enters the house. Read
the separate Consumer Product Safety
Commission Information for
grounding instructions.
Make a drip loop with the cable before it
4
enters the house to avoid water following
along the cable.
5
5
6
6
Toward TV Station