Regulations; Conversion And Spare Parts; Transport/Storage; Electric Current - emmeti SHARK E 4-130 Serie Manual De Instalacion Y Uso

3. Accensione 1. SAFETY

1.4 Regulations

The current versions of the following regulations must be observed during installation:
• Accident prevention regulations
• VDE 0370/Part 1
• Other local regulations (e.g. IEC, VDE, etc.)

1.5 Conversion and spare parts

The pump must not be technically modified or converted. It is not permitted to open
the pump motor by removing the plastic lid. Only use original spare parts. If the
above mentioned pumps are technically modified without manufacturer approval,
this declaration shall no longer be applicable.

1.6 Transport/storage

Unpack and check the pump and all accessories upon receipt. Report any damage
sustained in transit immediately. Ship the pump in the original packing only. The
pump is to be protected against moisture and mechanical damage and must not be
exposed to temperatures outside the range –10°C to +50°C.

1.7 Electric current

There is a danger of an electric shock when working with electrical current. The-
refore:
• Switch off the power before beginning work on the pump and make sure that it
cannot be switched on again.
• Do not kink or jam the power cable or allow it to come into contact with heat
sources.
• The pump is protected against drips in accordance with IP protection class (see
rating plate). Protect the pump against water spray. Do not immerse in water or
other fluids.
GB GB
25