Quick Start Guide
GO SOLO
High-Definition Audio/MIDI Interface
for Mobile Devices
(EN) Getting started
Connect GO SOLO to a computer, phone or tablet
using the included cables. If using the provided
lightning cable, insert a pair of AA batteries to power
GO SOLO, or connect a 5 V power supply (not
included) to power GO SOLO and charge your iOS
device.
Connect microphone, instrument or line-level
source to the input using XLR or 1/4" cables.
V 1.0
Plug a pair of headphones into the HEADPHONE
output. Set LEVEL control to minimum to start.
To enable phantom power move the 48 V power
switch to the ON position. The 48 V LED on the front
panel will light blue.
While speaking into the microphone or playing
your instrument, turn up the GAIN wheel. The SIG
LED should light green to indicate a signal present. If
the SIG LED lights red, turn the GAIN wheel down to
avoid clipping.
Connect MIDI devices to the mini 2.5 mm input
and output jacks using the included adapter cables.
Download your favorite TC Helicon app to begin
experimenting with effects.