Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
LumaPro Operating Instructions
WPL80 Wiring Diagram
Installation & Operation
Disconnect the power by turning off the circuit breaker or by removing the
appropriate fuse at the fuse box. Turning the power off using the light switch is not
sufficient to prevent electrical shock.
1.
Drill three mounting holes into mounting surface using a 3/8" drill bit. Use template
to locate mounting holes.
2.
Use a screwdriver to loosen (2) screws securing fixture door. Remove fixture rear
housing from fixture.
3.
Use a flat head screw driver to remove appropriate wire way covering from back
plate of housing.
4.
Take care to avoid damaging driver, wires and quick connectors and drill holes
through castings over fixture mounting holes.
5.
Affix fixture to mounting surface by installing anchors (not supplied) through
fixture mounting holes into holes drilled into the mounting surface. Be sure to
use an anchor appropriate for the mounting surface in which the fixture is
installed.
6.
Add ¼" bead of exterior grade silicone
sealant around the perimeter of the wall
pack on the wall to inhibit any moisture
from attachment screws. Remove the
pull-through plugs from the two weep
holes at the bottom of the fixture front
housing to reduce condensation buildup
and avoid water buildup within the fixture.
(see photo on right)
LED Wall Pack
Fixtures
4
446M62, 446M63, 54EP98
Publicidad
Tabla de contenido
