Installing Batteries - Plantronics Vista M22 Manual Del Usuario

Connecting the M22 to your telephone and headset
Unplug the handset coiled cable from the telephone base and plug it
into the port labelled with the handset symbol on the M22.
Insert the coiled cable from the M22 port labelled with the
telephone symbol into the handset cord port on your telephone.
To connect your headset, put the 2 halves of the Quick Disconnect™
(QD) connector together. Your headset and M22 are both supplied
with QD connectors. (See diagram).
Refer to your headset user guide for further information on your
headset.
NOTE The telephone must be disconnected from the network prior to
installing the M22. After installation please reconnect the telephone
before use. For more information please visit:
vista-m22

Installing batteries

The batteries on your M22 may need to be installed before you can
use your headset. You should disconnect your telephone from the
network before doing this.
To install the batteries, remove the battery cover on the side of the
M22 by pressing on the grips and pushing down.
Put the batteries into the compartment as shown on the inside of
the battery compartment, and replace the cover.
The M22 has a low battery indicator which gives 3 beeps when you
begin a call. If you hear this then replace the batteries as soon as
possible.
Setting the 7-position slide switch
The M22 is supplied pre-set to position 5. Try out the product at
this setting and adjust if necessary. Remove the mini-screwdriver
from the base of the M22 by sliding it out of the bracket. Use
the screwdriver to set the switch to the correct position for your
telephone. For a compatibility guide on which switch setting is
plantronics.com/product/
required, please visit: plantronics.com/product/vista-m22
on the "support" tab.
Fitting and removing the switch cover
On the left of the M22 is a cover. To remove it, hold the M22 firmly
and put your thumbs on the cover grips. Press and slide the cover
downwards. This gives you access to the adjustments for the
transmit level and the 7-position switch.
Adjusting the transmit level
The transmit level is how loud or quiet your voice is heard by people
on the other end of the line.
The M22 can be adjusted to set the optimum transmit level.
However, you need to fully install your headset before you make this
adjustment.
When you have completed your headset installation, put on your
headset and make a call to a colleague. Use the screwdriver to
adjust the dial until the ideal sound and tone levels are reached.
Turn the dial clockwise to increase the sound level, anti-clockwise to
decrease. The sound level should be the same as when you are using
the handset. Once you have set this, the dial only needs adjusting if
you change your telephone.
When you have finished making adjustments, replace the security
cover and the screwdriver for future use.
Making and taking calls with the M22
Some phones can be programmed to allocate a button on the
telephone for headset use. This allows you to take a call by simply
pressing this button. Please refer to your phone user guide for further
instructions. For other phones, please follow the instructions below.
The M22 has 2 modes –
1. Handset 2. Headset
and click