Automatic Shut Off - bhp WS-Q-11 Manual Del Usuario

This hea ng device is not suitable for assembling in vehicles and machines.
In order to avoid a hazard due to inadvertent resetting of the thermal cut out. This
z
appliance must not be supplied through an external switching device, such as a timer, or
connected to a circuit that is regularly switched on and off by the utility.
CONTROLS
BUTTON
means " DO NOT COVER ".

AUTOMATIC SHUT OFF

In case of overheating the appliance will automatically be shut off. If this occurs the electric
fireplace must be disconnected from the power outlet. The electric fireplace has to cool
down for approximately 20 minutes before reuse. Be sure that the air inlets and air outlets
are kept clean of dust, fluff, etc.
MAINTENANCE
Before carrying out maintenance work, disconnect the appliance from the power supply!
All manuals and user guides at all-guides.com
ON: Enables touch panel functions and remote control. Turns on flame effect.
OFF: Disables touch panel functions and remote control.Turns off flame effect.
TIMER button: Controls timer settings to turn off fireplace at selected time.
Settings range from 0.5 hours to 7.5 hours.
FLAME "-": Makes flame effect dimmer.
NOTE: Flame effect stays on until power button is turned off. Flame effect
must be on for heater to turn on.
FLAME "+": Makes flame effect brighter.
NOTE: Flame effect stays on until power button is turned off. Flame effect
must be on for heater to turn on.
HEATER button: Turns heater on and off.
NOTE: The heater only works when the flame effect is on. If the flame effect is
off, the heater will not turn on.
NOTE: To prevent overheating, the heater blows cool air for 10 seconds
before the heater turns on, and after it turns off.
FUNCTION