Replacing The Cartridge; Proceed As Follows; Disposal; Information - LIVARNO home WU6823481-8 Instrucciones De Montaje

A new LED insert can be obtained from the specified
service address.
To replace the LED insert, proceed as
follows:
Use the LED installation key
cap on the tap spout
18
Remove the silicone seal
the LED installation key
LED insert from the aerator housing
20
Install the new LED insert and the silicone seal
in the opposite way to disassembly.

Replacing the cartridge

Cartridges are wearing parts that must be replaced
at regular intervals depending on the lime content
and contamination levels of the water. If the tap lever
becomes stiff to operate, this can be a sign that the
cartridge must be replaced. Replacement cartridges
can be obtained directly at the specified service point.

Proceed as follows:

Carefully remove the hot / cold plaque
the tap lever with the help of a small flat-tip
3
screwdriver.
Loosen the underlying Allen grub screw
the Allen key by turning it anti-clockwise for
9
a few turns. Do not unscrew the Allen grub screw
completely, only loosen it until the tap lever
2
can be easily removed.
Remove the tap lever
Unscrew the cartridge covering ring
hand in an anti-clockwise direction.
Unscrew the locknut
pliers in an anti-clockwise direction.
Pull the cartridge
6
Carefully insert the new cartridge into the
cartridge base .
7
Make sure that the seals under the cartridge
are positioned correctly and that the leads are
inserted into the openings provided.
Screw the locknut
5
syphon pliers.
Screw in the cartridge covering ring
by hand.
to remove the
17
.
23
and then – using
19
again – remove the
17
.
21
from
1
using
2
.
3
by
4
using fitting or syphon
5
out of the cartridge base
tight using fitting or
tightly
4
Insert the tap lever
Fix the tap lever
screw in a clockwise direction using the Allen
2
key .
9
Insert the hot/cold plaque
. Pay attention to the correct orientation:
3
left = red (hot water)
right = blue (cold water).
Note: If you tighten the cartridge safety ring
too firmly, the tap lever
to move. In this case, slightly loosen the car-
tridge safety ring again.

Disposal

The packaging is made entirely of recyclable mate-
rials, which you may dispose of at local recycling
facilities.
Contact your local refuse disposal authority for more
details of how to dispose of your worn-out product.
To help protect the environment, please
dispose of the product properly when it
has reached the end of its useful life and
not in the household waste. Information
on collection points and their opening
hours can be obtained from your local
authority.
3

Information

Checking if tap water
is drinkable
. Ask your local authorities whether the water in your
7
town / municipality is drinkable.
In general the following recommendations apply
for the drinking water quality of tap water:
Do not use any stagnant water to prepare dishes
or drinks, and in particular to feed infants.
Failure to observe these instructions may have
negative health effects. You can tell when water is
fresh because it comes out of the tap noticeably
colder than stagnant water.
into the cartridge.
3
by tightening the Allen grub
3
into the tap lever
1
can be very difficult
3
GB/IE 17