Vibration Information - JCB -18BLDD Instrucciones De Funcionamiento

VIBRATION INFORMATION

Vibration total values (triax vector sum) determined according to EN 62841-1 and
EN 62841-2-1
Drilling into Metal
WARNING!
The vibration emission value of the power
tool is tested under EN 62841-1 and EN
62841-2-1, and can vary during operation
depending on the following usage conditions:
How the tool is used and the materials
m
being cut or drilled.
The tool being in good condition and well
m
maintained.
Using the correct accessory for the tool and
m
ensuring it is sharp and in good condition.
The tightness of the grip on the handles and
m
if any anti-vibration accessories are used.
The tool being used as intended by its
m
design and these instructions.
The declared vibration total value may also
m
be used in a preliminary assessment of
exposure.
THIS TOOL MAY CAUSE HAND-ARM
VIBRATION SYNDROME IF USAGE IS
NOT ADEQUATELY MANAGED.
12
Vibration Emission Value (a
Uncertainty (K)
)
4.0 ms
h,D
1.5 ms
WARNING!
To be accurate, an estimation of exposure
level in the actual conditions of use should
also take account of all parts of the operating
cycle. These include times when the tool is
switched off and when it is running idle but
not actually doing work. This may significantly
reduce the total exposure level over the
working period, helping to minimize your
vibration exposure risk.
ALWAYS use sharp and undamaged bits,
m
chisels, drills and blades.
Maintain this tool in accordance with these
m
instructions and keep well lubricated (where
appropriate).
If the tool is to be used regularly then invest
m
in anti-vibration accessories.
Avoid using tools in temperatures of 10
m
or less.
Plan your work schedule to spread any high
m
vibration tool use across a number of days.
Instruction & User Manual
-2
-2
C
°
JCB-18BLDD