Emprex LM-1902 Manual Del Usuario página 2

Check the package contents, you should find the following items;
LCD Monitor Monitor Base
(the shape of base
may vary according
to he monitor model)
Monitor installation
1.Setting up the monitor
1.1 Take out the monitor and monitor base from the package.
1.2 Place the detached monitor base on the desk.
1.3 Grasp the monitor with both hands and securely attach the monitor by sliding the monitor neck
into the base (Ensure the direction of the base is correct)
2.Connecting signal cable
2.1 Switch off your computer.
2.2 Connect the signal cable to the D-SUB or DVI port at the rear of the monitor and tighten the connector screws
2.3 Connect the other end of signal cable to the computer's VGA port and tighten the connector screws.
2.4 Note: Ensure the display setting does not exceed 1440*900, 75Hz.
3.Connecting audio cable (with audio option)
3.1 Plug the audio cable into the AUDIO port at the rear of the monitor.
3.2 Plug the other end of the audio cable into the audio port of your
computer or other audio source.
4.Connecting power
4.1 Plug the female end of the power cord into the POWER port at the rear of the monitor.
4.2 Plug the male end of the power cord into a power outlet.
5.Switching on
5.1 Switch on your computer.
5.2 You should now be able to see the picture. If not ,
refer to the trouble shooting section of this guide.
All manuals and user guides at all-guides.com
Power Cord Analog Signal
(plug may vary Cable
according to the
electrical standards
for your area)
01
Digital Signal Audio Cable
Cable
(optional) (optional)
English
CD-ROM Quick Installation
Guide
(contains user manual)
POWER AUDIO DVI D-SUB