PNI AT198 Manual De Usuario

EN
PNI AT198 breath alcohol tester should be used only to give an indication of the possible
presence of alcohol in the breath. You should not rely upon it as the sole basis to
determine intoxication or whether it is safe to drive a vehicle, operate equipment, or
engage in dangerous activities.
Everyone has different body responds to alcohol consumption and his testing result only
as reference, not a subject standard for consequent decision.
The manufacturer, importer or distributor takes no responsibility whatsoever for the use of
this product for any reason. This product must not be used as a tool for determining
whether a person is able to operate a motor vehicle or device legally or safely. The intake
of any alcohol will impair reflexes and judgment to operate motor vehicle
Main Features:
◇ Advanced flat surfaced alcohol sensor
◇ Quick response, excellent accuracy
◇ Direct testing process LCD Indication
◇ Portable design
◇ No touch healthy breath design
◇ Visible and audio warning beyond pre-set limit
◇ Power saving design, low battery indication
Technical Information:
Flat-surfaced Alcohol Sensor
Detection Range: 0.00 - 0.20%BAC, 0.00-2.00‰BAC
Accuracy: ±0.02%BAC at 0.05%BAC
Pre-set Level: 0.05%BAC; 0.50‰BAC; 0.25mg/L; 0.50g/L
Warm-up Time: 18 counting down
Testing Time: < 8 Sec
Display: 3 digitals LCD
Power: DC3V（2×AAA batteries）
Working Environment: 0℃ - 50℃
Dimensions: 102mm X 37mm X 20mm
Indication:
0.00 mg/L
WAIT
The 'ALC Nose' breath alcohol tester can be quick for detection of alcohol in the breath. If
you are in excessive drink, the tester would give you audio warning beyond pre-set limit.
Operation Instruction:
1. Slide down to open the battery compartment, insert the batteries and close it carefully,
please note the correct polarity direction in the battery compartment, otherwise, you may
damage the unit.
2. Press the 'switch' button for 1sec, the backup lamp would on, with a buzzer brief
0.00 - 1.00mg/L; 0.00 - 2.00g/L
≤95%RH No dews
Breathed Alcohol Contents
In Warm-up, please Wait
Battery used up, please replace
@50g
Gas Entry
LCD Screen
ON Button
Battery
Room