Cleaning And Storage - Commodore CM1014 Manual De Instrucciones

-Press the button "MODE" to select the desired wind mode,
Normal-Natural-Sleep.
-If Normal mode is selected wind will work normally.
-If Natural mode is selected wind will start working normally than
stop a few seconds and then work normally again.
-If Sleep mode is selected wind will start working normally, than
after some minutes wind speed will decrease.

CLEANING AND STORAGE

-Make sure that the appliance is disconnected from the power
supply before cleaning.
-Do not use abrasive detergents or products that could damage the
appliance. Simply clean the surface with a wet cloth.
-Do not immerse the appliance in water or any other liquid.
-Store the appliance in a safe and dry place.
Cleaning the air inlet filter:
-Remove filter by pulling them out.
-Use a soft brush and running water to clean them. Let them dry
before assembly again.
TECHNICAL DATA
220-240V ~ 50/60Hz 60W
This device conforms to the safety requirements and provisions of
directives 2014/35/EU on Low tension devices and 2014/30/EU on
Electromagnetic Compatibility.
Description
Maximum fan
flow rate
Fan power
imput
Service value
Standby power
consumption
Symbol Value
F 3,9
P 52,85
SV 0,07
P 0,41
SB
7
Unit
m3/min
W
m3/min (W)
W
EN