plastia urbalive ROBIN Manual De Instrucciones

ROBIN
(EN)
Bird-feeding set
This feeder is designed for outdoor use.
The pack includes:
• 1 food reservoir – fat balls
• 1 food reservoir – loose mixture
• 2 roofs
• 10 perches for the loose mixture
reservoir (2 spares)
• 10 plugs for the loose mixture
reservoir (2 spares)
• 2 cords
• Spare parts: 10x perches, 10x plugs
Spare perches and plugs can be used
to mount another feeder for the loose
mixture instead of a fat ball feeder.
Instructions were made in cooperation
with the Czech Society for Ornithology.
Why use the Robin bird-feeding set?
Use the Robin bird-feeding set during the winter. Two
reservoirs designed for different food types mean you can fill
the feeder with both loose food and fat balls. This variability
means there will be a lot of activity around the feeder all winter,
while you will also be helping birds survive this harsh season.
What to fill your feeder with
Add food to the feeder regularly, as needed and every day.
Birds quickly get accustomed to food sources in the winter
and come to depend on them. They will then fly to your feeder
every day, and usually at the same time.
Food for our wintering feathered friends should mostly be
plant-based, with various seeds, kernels, berries and other
fruits. Most birds that commonly visit feeders like sunflower
seeds best, and these also offer complete nutrition. You can
supplement these with cereal grains like oats, buckwheat,
millet and wheat. Birds also welcome legumes, maize and
special mixtures with dried insects. We always recommend
mixing larger seeds into a loose mixture. If you only use
small seeds, such as millet, the seeds may fall out of the
feeder. Loose mixtures of seeds, nuts and berries will be
especially appreciated by titmice, sparrows, chaffinches and
greenfinches. Any food that falls onto the ground will be a
feast for blackbirds and chaffinches, which do not usually visit
feeders otherwise.
A feeder with a fat ball reservoir is an ideal solution if you
cannot top up the feeder every day. The nets must always be
removed from the balls! We recommend using fat balls that do
not contain palm oil. You can treat titmice, woodpeckers and
nuthatches with fat balls.
Assembly, installation
Feeder for fat balls:
1) Insert the cord through the hole in
the roof and tie it off.
2) Place the fat balls without their nets
into the reservoir.
3) Attach the roof and turn it until
catches click into the grooves.
4) Install your feeder by hanging it using the cord.
Feeder for loose mixtures:
1) Insert the cord through the hole in
the roof and tie it off.
2) Snap the plugs and perches into the
reservoir in the following order: top row
plugs, second row perches, third row
plugs, bottom row perches. This order
must be used to ensure the necessary
spacing between the perches so that
birds can comfortably fit on the feeder.
3) Pour in your mixture.
4) Attach the roof and turn it until the catches click into the
grooves.
5) Install your feeder by hanging it using the cord.
Placement
It is best to place the feeder in a quiet place out of the
wind, ideally 2-3 m from bushes and denser vegetation
and approximately 1.5 m above the ground to make it less
accessible to cats or other predators.
Set care maintenance and cleaning
Clean the set regularly, including around it, to prevent the
possible transmission of infectious diseases. Remove any
peeled seeds and husks, droppings and uneaten food. There
is no need to feed birds in the summer as nature provides
enough food for them.
Avian trichomoniasis, also called feeder disease, is a parasitic
disease. Trichomoniasis is caused by a poultry parasite
(Trichomonas gallinae). It is transmitted by direct contact,
which can occur at feeders. If you see visibly ill (lethargic,
abnormal skin formations or obviously damp feathers around
the eyes and beak) or even dead birds on or around the feeder,
stop feeding immediately, disinfect the feeder, and allow it to
dry properly. Start feeding again after 14 days at the earliest.
Disassembling
To disassemble the product, reverse the way you have
assembled it. Clean it and store.
Disposal
All product components should be disposed of ecologically.
The disposal must be carried out in accordance with the
regulation of the Government or the law.
Guarantee
The product is guaranteed for the period of 24 months
from the date of purchase. The guarantee is granted only
in eligible guarantee claims, i.e. in the cases of material or
manufacturing defects. The guarantee is claimable only
when the product is used according to the Instructions for
use.