Craftmade accolade TH013 Guia De Inicio Rapido página 3

TH013 Thermometer/Clock Assembly
PARTS:
Foot Tab Key Stake
4 Pcs. 2 Pcs. 4 Pcs.
Hole Wood
Covers Top/Bottom Pole Screw
3 Pcs 2 Pcs. 3 Pcs
ASSEMBLY:
1) Base can be installed with adjustable screw-in foot tabs to stand on hard surfaces, stakes
for insertion into grass/soil surfaces, lag bolts for cement surfaces or wood screws for deck
installation. Thread foot tabs or stakes into the four holes under base. If foot tabs are used,
adjust height as necessary leveling fixture for uneven surfaces. If stakes are used, find level,
firm grass/soil area for inserting stakes. If lag screws are used, insert lag screw and secure
top portion onto base using lock washer, washer and hex nut. If wood screws are used, screw
firmly onto level wood surface. Plug hole where screws were inserted with Hole Cover.
2) Attach decorative bottom onto base followed by
the bottom pole. Next, slide coupler onto bottom
pole and slowly slide to bottom of base (do not
secure yet). Attach top pole to bottom pole.
Finally slide decorative coupler back up to center
of entire pole, so it covers the seam between
top and bottom poles. Using the provided allen
wrench, tighten threaded nipple embedded inside
coupler until it is tight and secure.
3) Attach clock/temperature display head to center
pole by inserting the center pole into the fixtures
bottom cup. Using allen wrench, turn embedded
set screws at bottom of head clockwise until it
catches pole and head is secure.
E3
All manuals and user guides at all-guides.com
40
20
0
-10
0
-20
-10
40 50
30
20
10
%
0
HUMIDITY
Base 1 Pcs. Double Sided Head 1 Pcs.
Hex Nut
3 Pcs
Washer
3 Pcs
Lock Washer
3 Pcs
Lag Bolt
Decortive Bottom Allen Wrench
3 Pcs
1 Pcs. 2 Pcs.
Step 1
Base
Foot Tab
Stake
Step 2
60
80
10 20
30 100
TEMPERATURE 40
120
50
C F
60
30
70
80
90
BARO
Cement Installation
Replacing Batteries: Installed On Side of Housing
Look for curled tab on side of housing. Pull and slide tab
downward to access battery casing. Insert batteries match-
ing the "-" and "+" markings, as indicated on the inside of
the battery housing, to the markings located on the battery.
Replace battery cover by sliding cover into place.
E4
Top Pole
1/8" Allen Wrench
Coupler
Bottom Pole
Wood Deck Installation
Step 3
3/8" Allen Wrench
Step 1
Step 2