RCA PCHSTAB1R Guia De Inicio Rapido

All manuals and user guides at all-guides.com
Bumper pad
Back
rest
Charger (front view)
IMPORTANT: This charger comes with a bumper pad installed on the charging well adapter's back rest. This bumper pad helps keep your iPhone or iPod in
place while it's charging. However, some models of iPhone or iPod might not fi t with this bumper pad installed--you might need to replace the bumper pad with
the smaller bumper included, or remove the bumper pad entirely.
Note: If you have the docking well insert that came with your iPhone or iPod, you can use it instead of the well insert that comes with the charger. Just pull the charger's
docking insert out and replace it with the insert made specifi cally for your iPhone or iPod model.
First, test your iPhone or iPod with the bumper pad in place. The iPhone or iPod should slide straight down onto the dock connector easily--DO NOT force it
onto the dock connector. If your iPhone or iPod does not fi t in the well or go easily onto the dock connector, try the other, smaller bumper pad included in this
package.
To change the bumper pad:
1) Pull the front of the bumper pad gently to remove it from the back rest.
2) Put the smaller bumper pad on the back rest. Insert the bumper pad's three rubber bumps into the three holes on the back rest and press it to make sure it's
in place.
Try docking your iPhone or iPod in the charger with the smaller bumper pad to make sure it fi ts. If your iPhone or iPod still does not fi t in the well or go easily onto
the dock connector, remove the bumper pad and try charging with just the back rest (no bumper pad).
PCHSTAB1R 00