Publicidad
Idiomas disponibles
Idiomas disponibles
Weather Station Adjustment
Instruction Sheet
Assembly:
Time: 5-10 minutes
Tools Required: Screwdriver, Hammer
Usage:
When using this weather station outside, place unit in shaded area away from direct
sunlight for most accurate reading of gauges, as direct sunlight may cause some
deviation in gauge readings.
Troubleshooting (Adjusting Gauges):
The various gauges contained in this product are calibrated to reflect the current
atmospheric conditions present during the time of this product's assembly. Vibration
during the transportation of this product may alter the preset readings and accuracy
of each gauge. To ensure the proper reading of each gauge, it is suggested that each
unit be checked for accuracy before use. For accurate atmospheric measurements
refer to a reliable source such as the newspaper, television, radio, and/or the internet.
If adjustment is necessary, please follow the below instructions for each gauge:
1) Clock adjustment:
a) Remove round plastic cap to expose adjustment dial.
b) To adjust the Clock reading, turn adjustment dial to adjust needle on the face of
the unit.
2) Temperature gauge adjustment:
a) Remove round plastic cap to expose adjustment dial.
b) To adjust the Temperature reading, turn adjustment knob marked "Temp" to
adjust needle on the face of the unit.
Note: Temperature gauge accuracy is +/- 2 degrees Celsius or +/-3 degrees Fahren-
heit.
1) Humidity gauge adjustment:
a) To adjust the Humidity reading, turn adjustment knob marked "Humid" to adjust
needle on the face of the unit.
b) It is suggested that adjusting humidity gauge be done every six months.
Note: Humidity gauge accuracy is +/- 5%.
E1
All manuals and user guides at all-guides.com
Remove round plastic
cap to adjust Clock
Adjustable Knob for Clock
Adjustable Knob for Temperature
Adjustable Knob for Humidity
Installing and Replacing AA Battery for Clock:
On back of clock, remove round plastic cap by pulling metal ring. Snap off the battery
cover located on the bottom of the clock's gear box
Insert battery matching the "-" and "+" markings, as indicated on the inside of the
battery housing, to the markings located on the battery. Replace battery cover by
snapping cover into place, and re-attach round plastic cap.
MADE IN CHINA
Battery Cover
E2
- AA 1.5V +
MADE IN CHINA
- AA 1.5V +
MADE IN CHINA
Battery
Publicidad
