Publicidad
All manuals and user guides at all-guides.com
EN
This manual contains important information that should
be kept for future reference.
Self-assembly.
Warning! Keep children away from the assembly area.
Leave the plastic bags out their reach. The small parts
pose a choking hazard.
Materials
Structure: lacquered oak veneered particle board, tem-
pered glass 10 mm.
Feet: polypropylene.
Assembly Instructions
In order not to lose components, do not throw the pack-
aging before completing the full assembly.
Before beginning assembly, identify all the components
using the manual.
This product must be assembled by an adult.
Plan to assemble the product as close as possible to
where it will be installed.
Assemble on a clean, flat surface.
Do not use an electric screwdriver.
Remove the glass parts carefully on a clean, soft surface
free of defects that can scratch or break.
The product cannot be assembled more than one time.
Warning! Before drilling, make sure that no pipes or
cables will be present in the drilling area. Fix the prod-
uct to the wall to ensure its stability. Use the type of
screws and wall plugs for the supporting material.
With time, the bindings can lose their effectiveness.
Regularly check the tightening of screws. If necessary
tighten.
Recommendations for use
This product is designed for indoor use only.
Do not climb the product.
Do not overload shelves.
Check the proper assembly before each use.
The wood-based products, particle board, painted, var-
nished and / or lacquers may emit an odor when opened.
This smell disappears after a few weeks if the room is
properly ventilated.
Maintenance
Part(s) of wood
Remove dust regularly with a dry cloth.
Clean with a soft, damp cloth. Then wipe with a clean dry
cloth.
Wipe up spills immediately with a clean, dry cloth.
To prevent scratching, do not use a sponge or recurrent
grains detergent.
Do not use abrasive products.
The use of special products for the wood is not necessary
or recommended.
Marlyne – 05/2018
Do not place the product near a heat source (radiator,
fireplace ...) nor a moisture source. Heat and humidity
may damage the product.
In order not to damage the surface, it is recommended
not to deposit hot items Wet directly.
Clean with movements in the direction of the wood
fibers.
To restore the luster plating, pass a cloth soaked in
turpentine.
To restore the luster to varnishes, passing a woolen
cloth soaked in a mixture of equal parts household
alcohol and linseed oil.
Part (s) of glass
The glass used for accomplishing this is a tempered
glass. It is more resistant than conventional glass. In
case of breakage, tempered glass breaks into small
blunt pieces.
Clean with glass cleaner and a soft cloth, then wipe
with a dry and clean cloth.
Clean with soft circular motions.
Do not use abrasive products.
Do not get in directly suceptibles objects that would
scratch the surface.
Do not strike the glass with hard or sharp object.
Keep the label with lot number, it may be useful
in case of complaint.
If you have any comments or suggestions regarding
this product, assembly instructions or service received,
please enquire at your nearest store or contact us on
our website at: www.habitat.eu or write to this address:
HABITAT-70 AVENUE VICTOR HUGO 93300 AUBER-
VILLIERS-FRANCE.
1
b
Publicidad
