EN
This manual contains important information that should be kept for
future reference.
Self-assembly.
Warning! Keep children away from the assembly area. Leave the
plastic bags out their reach. The small parts pose a choking hazard.
Material
Structure and 1 door: melamine faced chipboard lacquered.
Top, shelves, central panels, bottom and 2 doors: walnut veneered
particlebord lacquered. (Juglans nigra ; Origin: Croatia)
Feet: solid beech lacquered. (Fagus sylvatica ; Origin: Slovenia)
Plates and rail: metal lacquered.
Assembly instructions
Before beginning assembly, identify all components using the
manual.
In order not to mislead components, do not throw the packaging
before completing the full assembly.
This product must be installed by an adult.
Plan to assemble the furniture as near as possible to where it will
be installed.
Do not use a power screwdriver as it may damage the panels.
Assemble on a clean, flat surface.
Warning! Before drilling, make sure that no pipes or cables will be
present in the drilling area. Fix the product to the wall to ensure its
stability. Use the type of screws and wall plugs for the supporting
material.
With time, the bindings can lose their effectiveness. Regularly
check the tightening of screws. If necessary tighten.
Recommendations for use
This product was designed for indoor use only.
Do not sit on the product.
Do not stand on the product.
Do not overload the shelves.
The wood-based products, particle board, painted, varnished and /
or lacquers may emit an odor when opened. This smell disappears
after a few weeks if the room is properly ventilated.
Maintenance
Remove dust regularly with a dry cloth.
Clean with a soft, damp cloth. Then wipe with a clean dry cloth.
Mop up spills immediately with a clean, dry cloth.
In order not to damage the surface, it is recommended not to file a
hot object or wet directly.
Do not use magazines or newspapers as a mat. The ink used may
leave traces that can stain permanently the furniture surface.
To avoid the appearance of marks, not to leave any stationary object
for more than two months.
To avoid scratches, do not use a sponge or recurrent grain cleaner.
Do not use abrasives.
The use of special products for furniture is not necessary or
recommended. Clean veneer with a damp cloth. Then wipe with a
dry cloth.
Do not use abrasives.
Maintain with movements in the direction of wood fiber. Do not place
the product near a heat source (radiator, fireplace ...) nor a moisture
source. Heat and humidity may damage the product.
Milla - 09/2021
Keep the label with lot number, it may be useful in case of
BC
complaint.
If you have any comments or suggestions regarding this product,
assembly instructions or service received, please enquire at your
nearest store or contact us on our website at: www.habitat-design.com
or write to this address: HABITAT, 70 AVENUE VICTOR HUGO, 93300
AUBERVILLIERS FRANCE.
1