Anatec MONOCOQUE S Manual Del Usuario página 23

Instructions for use of Anatec monohull
in fishing conditions
Baiting and removal of lines
more than just a radio controlled boat, the AnATec monohull has been specially designed to help in certain
technical aspects of fishing.
You will be able to set your lines or markers, and also bait over a long distance with great precision.
Located at the rear of the boat, the bait tray has a capacity of 1 kg (you can fill with any type of bait (boilie,
seeds, pellets, flour, etc). It opens and closes by using the switch «channel 5» on the remote.
VeRSIon 3 BInS
This model is the same as the monohull S but has two additional bait trays on either side of the boat.
each tray holds up to 1 Kg of bait bringing the total capacity of the monohull 3B to 3 Kg
The two side bins are provided with an instant opening system.
The opening control of these is independent.
Loading the tray with line.
Before handling, it is essential to ensure that the remote is switched on. otherwise, the door is free to open
under the weight of the bait.
Place the line in the tray by passing underneath and close the door by pressing the switch on the remote
control.
never operate the hatch of the tank by hand when the boat is switched on.
Be careful to position the line in the notch provided for this purpose.
Do not exceed 1 kg load in the tray. overloading can result in the destruction of the servomotor.
When the line is in place, it is strongly recommended not to reverse the boat as the line may be caught in the
propeller.
Lighting
With 4 ultra powerful LeD lights, two white at the front and two red at the rear, you can pinpoint the location
of the boat day and night, even at great distance.
To turn on the lighting circuit, activate the switch on the outer hull of the boat (19).
In general, the brightness or intensity of the LeDs shows how much control you have over the boat. If the boat
deviates from the intended path, the intensity of the LeDs will diminish.
23