Craftsman 580.752201 Instrucciones De Uso página 12

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

8.
Move throttle lever (A) to "Fast" position, shown here as
a rabbit•
To start the engine for the very first time:
9A. Push
primer bulb (B) firmly 5 times, waiting
2 seconds
between each push•
To start engine thereafter:
9B. Press primer bulb firmly 3 times, waiting 2 seconds
between each push• For a warm engine, DO NOT press
primer
bulb.
IMPORTANT: Before starting the pressure washer, be sure
/ou are wearing adequate safety goggles•
WARHIHG
Risk of eye injury.
• _
JSpray can splash
back or
propel objects•
Always wear safety goggles when using this equipment or in
vicinity of where equipment is in use.
Before starting the pressure washer, be sure you are wearing
adequate safety goggles•
NEVERsubstitute safety glasses for safety goggles•
10. When starting engine, position yourself as
recommended, grasp handle and pull recoil starter
lightly until you feel some resistance, then pull briskly•
11. Return recoil starter slowly• DO NOTlet rope "snap
back" against starter•
12. After each starting attempt, where engine fails to run,
always point gun in safe direction, press red button and
squeezespray gun trigger to releasehigh pressure•
WARHIHG
Starter cord kickback (rapid retraction) can result
in bodily injury. Kickback will pull hand and arm
_<
toward engine faster than you can let go.
Broken bones, fractures, bruises, or sprains
could result•
• NEVERpull starter cord without first relieving spray gun
pressure•
. When starting engine, pull cord slowly until resistance is felt
and then pull rapidly to avoid kickback•
. After each starting attempt, where engine fails to run, always
point spray gun in safe direction, press red button and squeeze
spray gun trigger to releasehigh pressure•
. Firmly grasp spray gun with both hands when using high
pressure spray to avoid injury when spray gun kicks back•
NOTE: Always keep the throttle lever in the "Fast" position
when operating the pressure washer•
WARNING
The high pressure stream of water that this
equipment produces can cut through skin and its
,_
underlying tissues, leading to serious injury and
)ossible amputation•
Spray gun traps high water pressure, even when
engine is stopped and water is disconnected,
which can cause injury.
• DONOTallowCHILDREN to operatepressure washer•
. Keephigh pressurehoseconnected to pumpand spraygun
whilesystemis pressurized•
• NEVER aim spraygun at people,animals,or plants•
. DONOTsecurespraygun in openposition•
• DONOTleavespraygun unattended while machine is running•
. NEVER usea spraygun whichdoesnot havea triggerlock or
triggerguardin placeandin workingorder•
• Alwaysbe certainspraygun,nozzles and accessories are
correctlyattached•
WARHIHG
_
ontact with muffler area can result in serious
burns•
_j
Exhaustheat/gases can ignite combustibles,
structures or damage fuel tank causing a fire.
. DONOT touch hot partsand AVOID hot exhaustgases•
• Allowequipment t o cool beforetouching•
. Keepat least5 feet (152cm) of clearance on all sidesof
pressure washerincludingoverhead•
• Codeof Federal R egulation (CFR) T itle 36 Parks,Forests,and
PublicPropertyrequireequipment p oweredby an internal
combustionengine to havea sparkarrester,maintained in
effectiveworkingorder,complyingto USDA Forestservice
standard 51B0-1C or later revision•Inthe Stateof California a
sparkarresteris requiredundersection4442 of the California
Publicresources code•Otherstatesmay havesimilarlaws•
12

Publicidad

Tabla de contenido
loading

Tabla de contenido