Stopping The Engine - Husqvarna Z 254 Manual Del Operador

OPERATION
3. Disengage the mower blades by pressing the
blade switch downwards.
4. Move the steering / park brake controls firmly
out to the locked position.
5. Move the throttle lever to the middle throttle
position. If the engine is cold, the choke
control should be pulled up.
6. Push in and turn the ignition key to the start
position.
IMPORTANT INFORMATION Do not
operate the starter for more than five seconds
each time. If the engine does not start, wait
approximately ten seconds before retrying.
7. When the engine starts, immediately release
the ignition key back to the run position.
8. Set the engine speed with the throttle. Let
the engine to operate at a moderate speed,
approximately mid throttle, for a short time
before use. USE FULL THROTTLE WHEN
MOWING.
Running
1. Release the park brake by pulling the steering
/ park brake controls inwards to the neutral
position at the same time.
NOTE: The mower is equipped with an
operator presence system. If the operator
tries to leave the seat with the engine running,
18
without first setting the park brake, the engine
will shut off.
2. Lower the mower deck to the desired cutting
height.
3. Move throttle control to full throttle (rabbit
symbol).
4. Engage the mower deck by pulling the blade
switch up.
WARNING! Make sure that no one is
near mower when engaging blade switch.
5. Pull control levers inward and slowly move
both control levers slightly forward to move
forward in a straight line.

Stopping the Engine

1. Move the throttle to the minimum position
(tortoise symbol).
2. Move the steering controls at the same time
out to the park brake position.
3. Disengage the mower deck by pressing the
blade switch down.
4. Raise the mower deck to the highest position.
If the engine has been worked hard, let it idle
at least 60 seconds to attain a usual operating
temperature before stopping. To prevent
fouling the spark plugs, avoid idling the engine
for longer periods.
5. Turn the ignition key to the stop position.
Remove key. Always remove key when
leaving the mower to prevent unauthorized
use.
IMPORTANT INFORMATION Leaving the
ignition switch in a position than OFF will cause
the battery to be discharged.
IMPORTANT INFORMATION
and leaving the machine, both steering / park
brake controls must be moved out to the locked
position at the same time.
When stopping