Error Codes - Amprobe TR100-A Manual De Uso

Cannot stop the downloading before completing all sample points
Ans: Make sure the sample rate is greater than 1-sec

ERRoR CoDES

Error Code Description
e01 probe is disconnected
e02 Value under the lower limit
e03 Value over the upper limit
e04 Value fails because of the relative original data error.
e11 RH Calibration error
The humidity sensor accuracy cannot be calibrated by the end user
due to special equipment requirements. please contact a qualified
calibration lab for calibration.
e32 Read/write eepRoM error
e33 Hardware error
10