Checklist Before Starting Engine - Snapper 580.752641 Instrucciones De Uso

,
Before connecting garden hose to water inlet, inspect
inlet screen. Cleanscreen (A) if it contains debris or have
it replacedif damaged. DO NOTrun pressure washer if
inlet screen is damagedor missing.
4. Run water through garden hose for 30 seconds to flush
it of debris. Turn off water.
NOTICE DO NOT siphon standing water for the water
supply. Use ONLY cold water (less than 100°F).
5. Connect garden hose (not to exceed 50 feet in length) to
water inlet. Tighten by hand.
NOTICE Using a One Way Valve (vacuum breaker or check
valve) at pump inlet can cause pump or inlet connector
damage.
• ThereMUSTbeat leastten feetof unrestricted gardenhose
between the pressure washerinletandanydevice,suchasa
vacuumbreakeror checkvalve.
• Damageto equipment resulting from failure to follow this
instruction will void warranty.
_i, WARNING Risk of eye injury.
Spray can splash back or propel objects.
6.
• Always wear indirect vented (chemical splash) safety goggles
marked to comply with ANSI Z87.1 when using or in vicinity of
this equipment.
NEVERsubstitute safety glasses or dry-condition goggles for
indirect vented safety goggles.
Turn ON the water, press red button (B) on the gun and
squeeze the trigger to purge the pump system of air and
impurities.
Checklist Before Starting Engine
Reviewthe unit to ensure you have performed all of the
following:
1. Be sure to read Safety Rules and Operationsections
before using the pressure washer.
2. Make sure handle is in place and secure.
3. Checkthat oil has been added to proper level in engine
crankcase.
4. Add proper fuel to fuel tank.
5. Checkfor proper hose connections (high pressure and
water supply) and that there are no kinks, cuts, or
damageto the high pressure hose.
6. Provide proper water supply (not to exceed 100°F).
10