Service Air Cleaner; Service Spark Plug; Carburetor - Craftsman 580.752510 Instrucciones De Uso

Ocultar thumbs Ver también para 580.752510:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Change oil while engine is still warm from running, as
follows:
1. Drain fuel tank by running pressure washer until fuel
tank is empty.
2. Disconnect spark plug wire and keep it away from spark
plug.
3. Clean area around oil fill, remove oil fill cap/dipstick.
Wipe dipstick clean.
4. Tip your pressure washer toward the oil fill neck to drain
oil into a suitable container. When crankcase is empty,
return pressure washer to upright position.
5. Slowly pour recommended oil (approximately 18 oz.)
into oil fill opening. Pause to permit oil to settle. Fill to
upper limit mark on dipstick.
6. Replace and tighten dipstick.
7. Wipe up any remaining oil.
8. Reconnect spark plug wire to spark plug.

Service Air Cleaner

Your engine will not run properly and may be damaged if you
run it with a dirty air cleaner. Service more often if operating
under dirty or dusty conditions. Replacements are available
at your local Sears service center.
To service the air cleaner, follow these steps:
1. Press latch tabs (A) on top of air cleaner cover (B), and
remove cover.
D
E
C
B
A
A
20
2. Carefully remove air cleaner (C) from base (D).
3. Clean air cleaner by tapping it several times on a hard
surface to remove dirt, or blow compressed air (not to
exceed 30 psi) through air cleaner from clean side that
faces engine.
NOTICE NEVER try to brush off dirt. Brushing will force dirt
into the fibers.
4. Wipe dirt from air cleaner body and cover using a moist
rag. Be careful to prevent dirt from entering air duct (E)
that leads to the carburetor.
5. Install clean (or new) air cleaner in base. Air cleaner
must fit securely in base.
6. Reinstall air cleaner cover.
NOTICE You can purchase new air filter elements by calling
1-800-4-MY-HOME (469-4663).

Service Spark Plug

Changing the spark plug will help your engine to start easier
and run better.
1. Disconnect the cap from the spark plug and clean area
around spark plug.
2. Remove and inspect spark plug.
3. Replace spark plug if electrodes are worn, or if insulator
is cracked or chipped.
4. For replacement, use recommended spark plug, NGK
BPR6ES.
5. Check electrode gap with wire feeler gauge and set gap
at 0.028-0.031 inches (0.70-0.80 mm), if necessary.
6A. When reinstalling original spark plug, tighten 1/8-1/4
turn after the spark plug seats to compress the washer.
6B. When installing new spark plug, tighten 1/2 turn after
the spark plug seats to compress the washer.
7. Attach the spark plug cap to the spark plug.
NOTICE You can purchase a new spark plug by calling
1-800-4-MY-HOME (469-4663).

Carburetor

If you think your carburetor needs adjusting, see your
nearest Sears service center. Engine performance may be
affected at altitudes above 5000 feet. For operation at higher
elevations, contact your nearest Sears service center.

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido