HumanTechnik time flash Instrucciones De Servicio página 11

Switching the flash on and off
The flash feature of the timeflash
alarm clock can be switched on and
off.
To switch the flash off, please proceed
as follows:
- Switch off the alarm and the tone
(Switches are pressed in, the green
edge is not visible).
- Now press the alarm repeat button
on the top side of the alarm clock
and keep it held down.
- Press six times on the left tone ad-
juster button (situated at the right
side of the volume control).
When pressing the button you will
hear a beep tone.
- Let go of the alarm repeat button.
The flash is now switched off.
To switch the flash on, please pro-
ceed as described above, but press
six times on the right tone adjuster
button.
The flash is now switched on again.
Special aspects
• The alarm signal is repeated after 5
minutes (autosnooze) unless you
press the Light/Snooze button or
the alarm ON/OFF button.
• The quartz mechanism of the alarm
clock has a backup power supply.
The clock will continue to operate
for about 2 hours if there is a power
failure. The alarm function and the
illumination are deactivated during
this period.
• The clock face illumination is also
activated when the alarm is trig-
gered.
• In addition to the green marking of
the Alarm ON/OFF switch, the
snooze button is also illuminated
when the alarm is triggered.
• The »time flash« uses a chase light
for signalling an alarm. During an
alarm the 6 LEDs at the frontside will
be switched alternately, creating
the chase light.
English 11