Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
2.
2-IH-1 SOAPSYSTEM
Select desired spray tip:
Low Pressure
Black
Use to apply
chemical
High Pressure
40° White
15° Yellow
0° Red
2550 PSI
2800 PSI
3100 PSI
2.3 GPM
2.7 GPM
2.8 GPM
,
*
Fordelicate rinse (lower pressure and higher flow),
for gentle cleaning of cars/trucks, boats, RV's, patio
furniture, lawn equipment, etc., select white 40°
spray tip.
*
Forgeneral rinsing (medium pressure and medium
flow), ideal for most all purpose cleaning such as
home siding, brick patios, wood decks, driveways
and sidewalks, garage floors, etc., select yellow
15° spray tip.
*
For maximum rinsing (higher pressure and lower
flow), for stubborn or hard to reach surface such as
second story surfaces, paint removal, oil stains, rust
removal or other stubborn substances (tar, gum,
grease, wax, etc.), select red 0° spray tip.
,
To apply detergent, applies project specific cleaners
to help break down stubborn dirt and grime on a
variety of surfaces, select black detergent spray tip.
Pull back on collar, insert new spray tip and releasecollar.
Tug on spray tip to makesure it is securelyin place.
Usage Tips
*
For most effective cleaning, keep spray tip from 8 to
24 inches (20 to 61 cm) away from cleaning surface.
,
If you get spray tip too close, especially using a high
pressure spray tip, you may damagesurface being
cleaned.
,
DO NOTget closer than 6 inches (15 cm) when cleaning
tires.
CAUTION
Chemicals can cause bodily injury, and/or property
damage.
NEVER usecausticliquidwith pressurewasher.
UseONLYpressure washersafedetergents/soaps. Followall
manufacturers instructions.
Cleaning and Applying Detergent with
the Project Pro® PerfectMix
TM
Siphon
Tn apply undiluted detergent using
the blue PerfectMix" siphnn,
felJnw these steps:
1.
Review use of black spray tip.
2.
Attach PerfectMix
TM
siphon hose to
pump and PerfectMix
TM
Extreme
Concentrate bottle.
3.
Make sure black spray tip is installed.
NOTE:Detergentcannot be applied with the
high pressure spray tips (Yellow, White or Red).
4.
Make sure garden hose is connected to water inlet.
Checkthat high pressure hose is connected to spray gun
and pump. Turn on water.
NOTICE
You must attach all hoses before you start the engine.
Startingthe enginewithoutall the hosesconnected andwithout
thewaterturnedONwill damage the pump.
Damage to equipment r esultingfrom failureto followthis
instructionwill void warranty.
5.
Start engine following instructions How to Start Your
Pressure Washer.
6.
Placethreaded end of detergent siphoning tube into
Extreme Concentrate detergent container. Tighten by
hand.
7.
Apply detergent to a dry surface, starting at lower
portion of area to be washed and work upward, using
long, even, overlapping strokes.
8.
Allow detergent to "soak in" for 3-5 minutes before
washing and rinsing. Reappiy as neededto prevent
surface from drying. DO NOT allow detergent to dry on
(prevents streaking).
For best results, scrub the detergent covered surface to help
remove stubborn dirt, grime and stains. For vehicles, use a
soft car wash brush or mitt. For decking, siding and
concrete, use a brush appropriate for the type of surface
being cleaned.
IMPORTANT:You must flush the detergent siphoning system
after each use by placing the filter into a bucket of clean
water, then run the pressure washer in low pressure for 1-2
minutes.
14
Publicidad
Tabla de contenido
