Publicidad
Idiomas disponibles
Idiomas disponibles
Content
Camera
Velcro-pad
Baseplate
ATTENTION! The application in cars for observation and accident reconstruction is not covered by the guarantee. Through a collision at a high
speed, the record can be deleted.
ATTENTION!
The privacy of others is protected by law and should be taboo. The recording of third party can be a illegal act. You are responsible for your
acting.
Start
Remove the film protecting the lens first. Put a suitable SD-Card (FCO
Slide the switch [1] to position "ON" and press the shutter button [2]; on the display appears "
Choose your mode by pressing the mode button [3] Start and stop each time by pressing the shutter button [2].
Download the data
Choose „
" and connect the FCO² with the supplied USB-cable and your PC.
The FCO² will be displayed as a single drive. Attend that network drives can interfere the FCO² drive.
Cut the network drives. Of course you can connect the SD-card directly to your pc card reader.
2
Charge the FCO
The charging starts on its own by connecting the FCO² with the PC.
It will take approximately 3 hours to charge the FCO².
The battery status is indicated in percent below modes as follows:
Recharge the cam when "
" is displayed.
FlyCamOne
Eyeletband
Servoarm + screw
2
Rapid Rush 4.0 2GB) into the SD-Card slot of the FlyCamOne
,
www.FlyCamOne.com
2
Baseplate w.Servo (inst. Baseplate)
USB-Cable
" for ready.
,
.
Exclusive SE version
Trigger-Controlcabel
2
2
(FCO
).
Publicidad
