PowerBoss 020262 Instrucciones De Uso página 10

PowerBOSS™
HOW TO USE PRESSURE
WASHER
If you have any problems operating your pressure washer,
please call the pressure washer helpline at 1-800-743-4115.
Pressure Washer Location
Pressure Washer Clearance
WARNING
Exhaust heat/gases can ignite combustibles,
structures or damage fuel tank causing a fire.
• Keep at least 5 ft. (152 cm) clearance on all sides of pressure
washer including overhead.
Place pressure washer in a well ventilated area, which will
allow for removal of deadly exhaust gas. DO NOT place
pressure washer where exhaust gas could accumulate and
enter inside or be drawn into a potentially occupied
building. Ensure exhaust gas is kept away from any
windows, doors, ventilation intakes or other openings that
can allow exhaust gas to collect in a confined area
(Figure 7). Prevailing winds and air currents should be taken
into consideration when positioning pressure washer.
WARNING
Running engine gives off carbon monoxide, an
odorless, colorless, poison gas.
Breathing carbon monoxide can cause nausea,
fainting or death.
• Operate pressure washer ONLY outdoors.
• Keep exhaust gas from entering a confined area through
windows, doors, ventilation intakes or other openings.
• DO NOT operate pressure washer inside any building or
enclosure, even if doors or windows are open.
Figure 7 — Pressure Washer Clearance
3800 PSI Pressure Washer
Typical Pressure Washer Shown
Exhaust Port
How to Start Engine
The best way to start your pressure washer for the first
time is to follow these instructions step–by–step.This
starting information also applies if have let the pressure
washer sit idle for at least a day.
1. Place pressure washer near an outside water source
capable of supplying water at a flow rate greater than
5.0 gallons per minute and no less than 20 PSI at
pressure washer end of garden hose.
2. Make sure unit is in a level position.
3. Check that high pressure hose is connected to spray
gun and pump. See "Preparing Pressure Washer for
Use" for illustrations.
4. Connect garden hose to water inlet on pressure
washer pump.
5. Turn ON water, point gun in a safe direction and
squeeze trigger to purge pump system of air and
impurities.
CAUTION
DO NOT run the pump without the water supply
connected and turned on.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
6. Attach nozzle extension to spray gun (Figure 8).
Tighten by hand.
Figure 8 — Connect Nozzle Extension to Spray Gun
7. Choose spray tip you want to use and insert it into
nozzle extension. See "How to Use Spray Tips".
8. Engage trigger lock on spray gun trigger (Figure 9).
Figure 9 — Spray Gun with Trigger Lock Engaged
10
OPERATION
Trigger Lock