Candy CDG31SPX Manual De Instrucciones página 15

between the maximum setting and the off position.
- If the burner is difficult to light on, or if the flame is tall or irregular, turn off immediately
turning the knob to "off" position and call Assistance Service.
- If the particular nature of the local gas supply makes it difficult to ignite the burners with the knob
turned to the maximum setting, repeat the operation without a pan in position and with the knob
turned to the minimum setting and without pan stands.
- Warning: The ignition device must not be used for more than 15 seconds. If after this length of time the
burner does not light, or if it goes out again accidentally, wait 1 minute before trying to ignite it again
Grids
The panstand grids are designed to make the appliance easy and safe to use. Always check the
panstand grids are properly positioned before using the appliance. Furthermore, always check the
protective rubber feet are all present and correctly positioned.
Grid for small pots or pans (optional - Fig.1A)
This is placed on top of the auxiliary burner grid (the smallest one) when pots or pans of reduced
diameter are used, to avoid unbalancing.
Special "WOK" support grid (optional - Fig.1B)
This is placed on top of the triple crown burner when using a "WOK" (concave bottom pan).
In order to prevent serious malfunction of the burner, never use a wok without this special grid
and never use the wok grid for flat bottomed pans
Choosing the right burner
The symbols stamped on the control panel (fig.2) near the knobs indicate which knob correspond
to which burner. To choose the most suitable burner, take into account the diameter of
the pan as well as the pan capacity (see table).
The diameter of the pan must be proportionate to the burner power in order to ensure high yield.
Pan diameter
Electric hotplates
Warnings:
-
Never cook food directly on the electric hotplates; always use suitable pots or containers
-
Absolutely do not leave the electric plates working without any pots on it.
These wrong use may cause overheating, damages to the appliance and fire hazard.
-
Take all precautions possible to avoid spilling liquids onto the hotplate when it is hot.
-
Do not use the appliance if the surface is broken or damaged; in case you find a crack on the
appliance, disconnect immediately he electric supply and contact the After-Sales service.
-
Bear in mind that the cooking zones remain hot for a relatively long time (about 30 min.),
after switching off.
-
Never clean with high-pressure water or steam-cleaning equipment.
-
Do not put flammable materials (paper, plastic, etc...) on the cooking zones (plates or glass-ceramic)
-
Do not allow heavy or sharp objects to fall on the glass-ceramic cook top.
-
Do not stare at the halogen lamps on the cook top.
-
Use flat bottomed pans only with a diameter large enought to cover the entire burner surface.
Burner
A Auxiliary
R Rapid
TR Triple-crown
Ø minimum Ø maximum
60 mm (with
140 mm
reducer)
200 mm 240 mm
240 mm 260 mm