Safety Instructions; Driver Installation - DeLOCK 90433 Manual Del Usuario

English
Description
This PCI Express card by Delock expands the PC by four SATA 22 pin ports. Up to four 2.5" SSD / HDD can be connected to this card.
When using more than one SATA port, there is the possibility to use different RAID modes.
HyperDuo support
The card supports a HyperDuo function. With this function it combines an SSD and an HDD to use the advantages of both data mediums,
the speed of an SSD and the capacity of an HDD.
RAID support
Furthermore, the card also supports various RAID modes such as RAID 0, 1, 10 or JBOD. Also, if enough SSD or HDD are installed, two
different RAID modes can be used at the same time. For example, two hard disks with RAID 0 and two hard disks can be configured in
HyperDuo or RAID 0 and RAID 1.
Specification
• Connectors:
internal:
1 x PCI Express x2, V2.0
4 x SATA 22 pin receptacle
• Chipset: Marvell 88SE9230
• Suitable for 2.5" SATA HDD / SSD:
SATA HDD / SSD up to 6 Gb/s
supports 5 V HDD / SSD
• Supports RAID 0, 1, 10, JBOD, HyperDuo Virtual Disk (Safe/Capacity)
• Bootable
• Supports Native Command Queuing (NCQ)
• Supports S.M.A.R.T.
• Supports TRIM
• Supports DevSleep
• Hot Swap
• Dimensions (LxWxH): ca. 227 x 120 x 20 mm
System requirements
• Linux Kernel 4.9.4 or above
• Windows 7/7-64/8.1/8.1-64/10/10-64
• PC with one free PCI Express slot
Package content
• PCI Express card
• 16 x fixing screw
• Driver CD
• User manual

Safety instructions

• Protect the product against moisture
• Avoid anti-static electricity when installing the card

Driver Installation

Note: Perform the driver installation before the hardware installation.
1. Switch on your computer.
2. Put the driver CD in the CD ROM drive.
3. Open Windows Explorer, select: CD-drive\MSU\MSUSetup.exe.
4. Follow the installation instruction and confirm the license terms.
5. The driver will now be installed.
6. After the driver installation please follow the hardware installation.
Hardware Installation
1. Turn off your PC and unplug the power cord.
2. Open the housing.
3. Insert the card straight and carefully into the free PCI Express slot, until it is well seated.
4. Connect your HDDs or SSDs to the SATA 22 pin connectors on the PCIe card and screw it.
5. Reattach the housing and connect the power cord to the AC adapter.
Installation
1. After restarting the computer, the PCIe card will be installed automatically.
2. You can now start to use the device.
-2-