Munchkin Auto Close Modern Manual Del Usuario página 7

How To Install How to Use
TOOLS NEEDED:
Wrench
2. Use the wrench to tighten the nuts on all 4 threaded
adjustment rods until the gate is secure. Tighten each
nut a little at a time, starting at the bottom of the
gate, then move to the upper hinge-side, and lastly
the upper handle side.
3. The nuts should be tightened until the handle latch
locks into frame and the red indicator near the handle
is no longer visible.
PLEASE NOTE: DO NOT overextend
the adjustment rods. If the gate is more
than 2.5" (63.5 mm) from the wall, you
must add an extension. See page 15
for additional extension configurations.
12
2
3
Red indicator
1/16" (1.5mm)
<2.5" (<63.5mm) <2.5" (<63.5mm)
OPENING YOUR GATE
Using your thumb, squeeze the button on the top of the handle. Pull the handle upward
to swing the gate open.
CLOSING YOUR GATE
Your gate has an auto close feature. The hinge will automatically slide the gate door back
to the closed and locked position. If you want the door to remain open for easy access,
open as wide as possible and the door will rest in a notch on the hinge until you nudge it
back towards the closed position.
PLEASE NOTE: Always check the handle to make sure that the gate is securely locked and
never leave your child unattended.
How to Use
13