HumanCentric 101-1048 Manual De Instrucciones página 3

STEP 2
Remove base
Place the monitor on a
1.
at surface (like the
edge of a table) so the
stand hangs over the
edge.
2.
While holding the base
with one hand, remove
and keep the eight screws
(you will use them in the
next step). Remove the stand
and put it in a safe place in case you
want to reattach it in the future.
STEP 3
Install ange
Align the hole in the
ange to the pin on the
back of the display.
Then secure the ange
using the ve ange
mounting screws
provided with the
adapter.
WARNING : Ensure that the display is full rotated forward
until it locks into position. If it does not lock, the 8-hole
plate will retract back into the display and is extremely
di cult to remove.
3