Audiolab LIVE AN8 Manual De Usuario página 3

2. INPUT CHANNEL SECTION
1. Balance Input
Electronically Balanced inputs acceptable a stand-
ard XLR male connector. +48V Phantom Power
available on each input Mic socket. And this switch
is on Rear Phantom Power.
2. Line Input
The unbalanced Mic input is provided for the use
of a unbalanced mic and is designed to accept a
unbalanced high impedance input signal (This use
for connection Deck, Turntable, Keyboardect.)
3. Insert
The INSERT is a break point in the input channel
signal path. It allows the signal to be taken out from
the mixer, through an external equipment such as
a compressor, and then back to the mixer to contin-
ue the final mix output.
4. Gain control
Adjusts input sensitivity from -60dB to -20dB with
the -20dB pad switch in the out position, and -40dB
to 0dB when the -20dB pad switch is pushed.
5.Low cut
The LOW CUT switch, 75Hz at a rate of 18dB per
octave.
6/7/8. 4-Band Fixed -
Frequency EQ
The stereo channels (9-16) have a 4-band fixed
- frequency equalization: LOW shelving at 80Hz,
LOW MlD peaking at 400Hz, HIMID peaking at 2.5kl-
lz, and Hl shelving at 12kHz. Each of these filters
provides up to 15dB of boost or cut. As with the
mono channels the circuit is flat (no boost or cut)
at the center detent positions.
9. AUX Send
Use this control to set the level of signal from ex-
ternal stereo source and the main signal control
is re controlled by STEREO or MONO section.
10. EFF
Use this control when you want to get effect
sound by adjustment of input signal. When
youdont use external source, digital delay will be
working which installed inside.
11. Pan
The pan control sends comtinuosly variable
amounts of the post fader signal to either the left
or right main busses. In the center position equal
amounts of signal are sent to the left and right
busses.
12. Mute
All output from the channel are enabled when the
MUTE switch released and muted when the switch
is down.
13. Channel Fader
This is function to adjust the volume of signal con-
nection in to each channel and adjust the volume
of output, together with master fader. Normal
operation is at the O mark, providing 4dB of gain
P. 3
- AUDIOLAB LIVE AN8
English version